User manual SANYO FY2010 OVERVIEW

[. . . ] Compatibility The projector widely accepts various video and computer input signals including: C o m p u t e r s , 6 C o l o r s y s t e m s ( PA L , SECAM, NTSC, NTSC4. 43, PAL-M, and PAL-N), Component video, S-Video and RGB scart. Simple Computer System Setting The projector has the Multi-scan system to conform to almost all computer output signals quickly. (p. 6) Digital Zoom (for Computer) The digital zoom function expands (to approx. 16 times of the screen size) the image size, allowing you to focus on crucial information during the presentation. [. . . ] (From 0 to 63. ) White balance (Green) Press the Point button to lighten the green tone and the Point button to deepen the green tone. (From 0 to 63. ) White balance (Blue) Press the Point button to lighten the blue tone and the Point button to deepen the blue tone. (From 0 to 63. ) Sharpness Press the Point button to soften the image and the Point button to sharpen the image. (From 0 to 15. ) Gamma Press the Point buttons to adjust the gamma value to obtain better balance of contrast. (From 0 to 15. ) Reset To reset the adjusted data, select Reset and press the SELECT button. The confirmation box appears and then select [Yes]. All adjustments returns to their previous figures. Press the Point buttons to adjust the value. Selected Image level Note: After adjusting any of the White balance Red, Green, or Blue, the Color temp changes to "Adj. ". 31 Computer Input Store To store the adjusted data, select Store and press the SELECT button. Select a level from Image 1 to 4 with the Point buttons and press the SELECT button. A confirmation box appears and then select [Yes]. Stored data can be called up by selecting "Image" in the Image Level Selection on page 30. Quit Exit the Image Adjust Menu. Store item Press the SELECT button at this item to store the adjusted data. · True, Full, and Digital zoom +/­ cannot be selected when 480i, 575i, 480p, or 575p is selected in the PC System Menu (p. 6). · Digital zoom +/- cannot be selected when Full or True is selected. 33 Video Input Input Source Selection (Video) Direct Operation Choose Video by pressing the INPUT button on the top control or the VIDEO button on the remote control. Top Control INPUT button Video Computer 1 Computer 2 Remote Control VIDEO button Video Menu Operation Input Menu icon 1 2 Press the MENU button to display the On-Screen Menu. Press the Point buttons to move the red framed pointer to the Input Menu icon. Press the Point buttons to move the red arrow pointer to Video and then press the SELECT button. Input Menu Move the pointer to Video and press the SELECT button. Note: - When the Input Search function is set On1 or On, the input signal will be searched automatically. (p. 45) - Computer is not displayed when the COMPUTER IN / MONITOR OUT terminal is set as Monitor out. (p. 45) 34 Video Input Input Source Selection (S-Video, Component, RGB Scart 21-pin) Direct Operation Choose Computer 1 by pressing the INPUT button on the top control or press the COMPUTER button on the remote control. Before using these buttons, correct input source should be selected through Menu operation as described below. Top Control INPUT button Computer 1 Computer 2 Video Remote Control COMPUTER button Computer 1 Menu Operation Computer 2 See Note at the bottom of this page. 1 2 3 Press the MENU button to display the On-Screen Menu. Press the Point buttons to move the red framed pointer to the Input Menu icon. Press the Point buttons to move the red arrow pointer to Computer 1 and then press the SELECT button. [. . . ] The projector cannot be turned on until cooling is completed. The projector is ready to be turned on with the POWER ON/STAND-BY button on the top control or on the remote control. The projector is in the Power management mode. The temperature inside the projector is abnormally high. [. . . ]