User manual SANYO HEC-SR1000K

[. . . ] Be sure to check that there is no-one (children in particular), or any pets under the foot rest prior to lowering the foot rest. In addition, do not leave the foot rest in the raised position when not in use. Do not attempt to stand on the arm rest, foot rest, or back rest. Otherwise, the user may fall over, resulting in injury. [. . . ] Also, clean the dust off the power plug periodically. Otherwise, electric shock, short circuit or fire may occur. Switch the power [OFF] instantly if there is a power failure, and also pull the power plug out from the outlet. Otherwise, it may become dangerous when the power is restored. Do not move the chair with a person on it. Otherwise, the chair may fall over, resulting in injury. Do not use the chair with other medical instruments (e. g. Otherwise, the user may feel sick or, it may cause other health problems. If the chair becomes inoperative, disconnect the power plug immediately to prevent accidents, and ask the sales agent for inspection/repair information. Otherwise, it may result in fire due to electric shock, current leakage, short circuit, etc. When the equipment will not be used for an extended period, be sure to disconnect the power plug from the outlet. (See page 10) LEG button Adjusts the angle of the foot rest. (See page 10) Pillow POWER switch Used to turn on/off the power source. (See page 8) (See page 12) RECLINING button Adjusts the angle of the back rest, foot rest and seat. The back rest, foot rest and seat are moved in conjunction with each other. (See page 10) 5 6 HOW TO PLACE THE CHAIR How to move the chair HOW TO INSTALL THE HEAD REST AND PILLOW 1 Raise the back rest. Movement becomes easier when the back rest is raised. (See page 10) of the chair, 2 Raise the front sidethe casters. and move it using PUSH PULL 1 Remove the screws (x2) from the head rest. Head rest inserting the head 2 Afterthe pipe, secure therest into head rest firmly with the screws (x2). Head rest Pipe Hole Screws Back rest Caster Screws NOTE Before moving the chair, be sure to remove the power plug from the outlet. Be careful not to step on the power cord during movement. Be sure to move the chair with the assistance of another person on an easily damaged floor surface or concrete surface. Before moving the chair, make sure that the Åñ head rest is securely attached. (See page 8) Be Åñ careful when moving the chair by holding the head rest as doing so may cause the head rest to tilt forward. [. . . ] Do not attempt to repair the equipment at home by yourself, as it is very dangerous. SPECIFICATIONS Power consumption Rated time Timer 100 W 30 min. 15 minutes 780 mm(30 11/16") [width] Å~1, 030 mm(40 9/16") [depth] Å~1, 230 mm(48 7/16") [height] ÅñWhen not reclined (with foot rest retracted) 780 mm(30 11/16") [width] Å~1, 740 mm(68 1/2") [depth] Å~715 mm(28 1/8") [height] ÅñWhen reclined (with foot rest set horizontally) Approx. 115 Å` 155Åã Back rest: Motor-driven type (Linked with foot rest and seat) Foot rest: Motor-driven type (Foot rest only) Approx. 24 Å` 36 kPa(3. 5 Å` 5. 2 PSI) ÅñThere is a slight difference according to the part. Sound and sensation during operation During use, the following sounds or sensation may be unavoidably generated because of its structure, but they are not problems. [. . . ]