User manual SANYO KMHS1272

[. . . ] 01_KMHS0972_EN. fm Page 2 Monday, October 17, 2005 10:54 AM Features This air conditioner is an inverter type unit that automatically adjusts capacity as appropriate. Details on these functions are provided below; refer to these descriptions when using the air conditioner. · Microprocessor Controlled Operation The interior compartment of the remote control unit contains several features to facilitate automatic operation, easy logically displayed for easy use. Simple One-touch Wireless Remote Control The remote control unit has several features to facilitate automatic operation. [. . . ] This function is convenient when gentle cooling is needed. 2 °F Setting temperature 2 °F Press the NIGHT SETBACK button B. In Heating Mode: ( ) 30 min. 30 min. Time When the night setback mode is selected, the air conditioner automatically lowers the temperature setting 4 °F when 30 minutes have passed after the selection was made, and then another 4 °F after another 30 minutes have passed, regardless of the indoor temperature when night setback was selected. This enables you to save energy without sacrificing comfort. This function is convenient when gentle heating is needed. Setting temperature 4 °F 4 °F Press the NIGHT SETBACK button 30 min. 30 min. Time OI-808-15-EG 15 01_KMHS0972_EN. fm Page 16 Monday, October 17, 2005 10:54 AM Operation with the Remote Control Unit (continued) 5. QUIET Mode QUIET Mode is used to reduce the fan sound of the indoor unit. · · In QUIET Mode, the fan rotates at a slower speed than the fan speed setting. If the unit is already operating with a very low airflow, the fan sound may not change even if the QUIET button is pressed. 6. HIGH POWER Mode HIGH POWER mode can be used to increase the output of the indoor unit for all operation modes except automatic operation. To cancel, press HIGH POWER button again. · When the HIGH POWER button is pressed, the unit operates at maximum output for 30 minutes, regardless of the desired temperature. The fan speed is 1 step above "High". HIGH POWER Mode cannot be used when the operation mode is Automatic Operation. QUIET Mode and HIGH POWER Mode cannot be used at the same time. NOTE · When set to High fan speed during heating operation, the fan runs at High fan speed even though the mark is displayed. · Depending on the operating conditions, the fan speed may be increased by a small amount only. · · 7. ION Mode The ION mode is used during operation to generate negative ions that freshen up the air in the room. · · · The indoor unit's ION lamp lights up while negative ions are being generated. ION "on" is the remote control unit's initial setting. The negative ions are generated from the negative ion generator. 16 OI-808-16-EG 01_KMHS0972_EN. fm Page 17 Monday, October 17, 2005 10:54 AM Special Remarks ``DRY'' ( ) Operation · · · Once the room temperature reaches the level that was set, the unit's operation frequency is changed automatically. During DRY operation, the fan speed automatically runs at lower speed for providing a comfortable breeze. [. . . ] The air intake grille can be removed in order to wash it with water. Cleaning the main unit and remote control unit Refer to "How to remove the anti-mold filter" and "How to replace the anti-mold filter" on page 23. When using a footstool or the like, be careful not to let it tip over. CAUTION Washing the grille with water · · Clean the grille gently using a soft sponge, or the like. Neutral detergent may be used to remove stubborn dirt. Then rinse thoroughly with water and wipe away any remaining moisture. Cleaning the negative ion generator Follow the steps below when the generator has become dirty. [. . . ]