User manual SANYO KMS2472

[. . . ] 01_KMS1872_En. fm Page 2 Monday, November 14, 2005 1:28 PM Features This air conditioner is an inverter type unit that automatically adjusts capacity as appropriate. Details on these functions are provided below; refer to these descriptions when using the air conditioner. · Microprocessor Controlled Operation The interior compartment of the remote control unit contains several features to facilitate automatic operation, easy logically displayed for easy use. Simple One-touch Wireless Remote Control The remote control unit has several features to facilitate automatic operation. [. . . ] In the event of power failure, the unit will stop. · 2. Manual fan speed Simply set the FAN SPEED selector button to the position. This automatically sets the best fan speed for the room temperature. If you want to adjust fan speed manually during operation, just set the FAN SPEED selector button as desired. Fan Only STEP 2 STEP 1 STEP 3 If you want to circulate air without any temperature control, follow these steps: STEP 1 STEP 2 STEP 3 Press the MODE selector button to switch to the fan mode Press the ON/OFF operation button. Press the FAN SPEED selector button to select the fan speed of your choice ( , or ). . OI-807-13-EG 13 01_KMS1872_En. fm Page 14 Monday, November 14, 2005 1:28 PM Operation with the Remote Control Unit (continued) 4. Night Setback Mode Night Setback Mode is used for saving energy. Press the NIGHT SETBACK button while operation. To release the night setback function, press the NIGHT SETBACK button again. In Cooling and DRY Mode: ( and ) When the night setback mode is selected, the air conditioner automatically raises the temperature setting 2 °F when 30 minutes have passed after the selection was made, and then another 2 °F after another 30 minutes have passed, regardless of the indoor temperature when night setback was selected. This enables you to save energy without sacrificing comfort. This function is convenient when gentle cooling is needed. 2 °F Setting temperature 2 °F Press the NIGHT SETBACK button 30 min. 30 min. Time 14 OI-807-14-EG 01_KMS1872_En. fm Page 15 Monday, November 14, 2005 1:28 PM Operation with the Remote Control Unit (continued) 5. QUIET Mode QUIET Mode is used to reduce the fan sound of the indoor unit. · · In QUIET Mode, the fan rotates at a slower speed than the fan speed setting. If the unit is already operating with a very low airflow, the fan sound may not change even if the QUIET button is pressed. 6. HIGH POWER Mode HIGH POWER mode can be used to increase the output of the indoor unit for all operation modes. To cancel, press HIGH POWER button again. · When the HIGH POWER button is pressed, the unit operates at maximum output for 30 minutes, regardless of the desired temperature. The fan speed is 1 step above "High". QUIET Mode and HIGH POWER Mode cannot be used at the same time. NOTE · Depending on the operating conditions, the fan speed may be increased by a small amount only. · 7. [. . . ] When using a footstool or the like, be careful not to let it tip over. CAUTION Washing the grille with water · · Clean the grille gently using a soft sponge, or the like. Neutral detergent may be used to remove stubborn dirt. Then rinse thoroughly with water and wipe away any remaining moisture. Cleaning the negative ion generator Follow the steps below when the generator has become dirty. For safety, be sure to turn the air conditioner off and also to disconnect the power before cleaning. [. . . ]