User manual SANYO LNS-M02 LENS REPLACEMENT AND INSTALLATION

[. . . ] When shipping the projector with the lens, remove the lens before shipping the projector. If you have any questions, contact the dealers. LIST Of CONTENTS following parts are included in the packing. [. . . ] Insert the Lens Attachment and secure with the four (4) screws (supplied). 5. ) Connect the Lens Motor Lead to the socket on the top loght of the Lens Attachment. 5 Screw Driver (supplied with the optional lens) Part No. (610 275 6029) Lens Attachment (supplyed with the projector) Lens Attachment 01 POA-LNA-01 Part No. (610 303 8742) Lens Attachment Socket Connector Lens Motor Lead Fig. 6 8 Grasp (release lock) the Lens Lock Lever and turn it fully upward. Grasp the Lens Lock Lever and turn the Lever f u l l y d ow nwa r d u n t i l l eve r i s Lo cke d (clicked position) properly. 8) After installing the lens, make sure the lens is not loose and properly installed. LENS LOCK RELEASE Grasp (unlock) Lens Lock Lever and pull upward. LENS LOCK Grasp (unlock) Lens Lock Lever and fully pull downward until it is locked (clicked). Fig. 8 9 T o ensure that the lens is securely fixed to the projector when mounting, be sure to attach the Safety Clamp (supplyed with the projector). There are two different types of Safety Clamps depending on the lens of the projector. Please use Safety Clamp of the SC-A type for this lens. Insert the removed screw to the Safety Clamp. Place the Safety Clamp in the location of the removed screw. Make sure that the Safety Clamp is mounted to hold the Lens Lock Lever in the lock position. [. . . ] As a guide, the distance is adjusted by approximately 30 mm for each 0. 1-mm thickness of the spacers. There are three types of spacers supplyed with the projector, and there are four of each spacer type. [. . . ]