User manual SANYO MZ7A-KC6A DIMENSIONS

[. . . ] Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. CAUTION: Changes or modifications not expressly approved by the manufacturer may void the user's authority to operate this equipment. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] 1 Press the + (or ­) button to set the WEEK (2ND) , then press the c button. Menu: 1ST, 2ND, 3RD, 4TH or LST (first, second, third, fourth or last) 2 Press the + (or ­) button to set the WEEK (TUE), then press the c button. Following the same procedure as above, set when the time is changed back from daylight saving time to standard time (the OFF settings). You must set this unit output to match the type (Timelapse or Real time VCR) and settings of the VCR used for recording. Using the + (or ­) button, select the desired "VCR MODE" setting, then press the l button. With a timelapse VCR Set the recording speed to use when an alarm trigger is received to match the alarm recording speed of the timelapse VCR. The available speeds are: 2 (2H) (Default setting), 12 (12H), 24 (24H), NC, F2 NC: When an alarm trigger is received, the recording speed is not Use this setting when using the SW output terminal on a timelapse VCR that does not output a switching signal in 2H mode. With a real time VCR Set the recording speed to use when an alarm trigger is received to match the alarm recording speed of the real time VCR. The available speeds are: 6 (6H) (Default setting), 18 (18H), NC, F6 NC: When an alarm trigger is received, the recording speed is not F6: Use this setting when using the SW output terminal on a real time Using the programmed recording mode you can decided to only output the recorded live pictures from a certain camera or to give priority to the pictures from a certain camera. this will set the programmed recording mode. MODE1: Only the live pictures from the camera for which programmed recording is set are recorded. Therefore, when using a recording speed other than 2H or 6H, do not use the F2 or F6 setting. Connect the multiplexer to a computer, using a 9-pin D-SUB cable (sold separately), then set the maximum communication speed between the unit and the computer. The unit address is displayed on the last line of the menu. The unit address can be set using the Interface setting DIP switches on the back panel of the unit. Using the + (or ­) button, select the desired "DATA SPEED" setting, then press the l button. When an alarm trigger is received from sensors such as a door bell, movement sensor, etc. You can set the display mode and the recording mode for the pictures from the concerned camera. Using the (SENSOR SET) settings (see page 32), the triggers received from the video sensors can be set to operate as alarm triggers. Using the + (or ­) button, select the desired setting, then press the l button. ⷠRepeat step 2, until all the settings are as desired. The available durations are (seconds): 1, 2, 3, 4, 5, 10, 20 (in 10 seconds increments). [. . . ] The DIP switches need to be set when a computer, special controller, etc. connected to the RS-232C or RS-485 connectors is used to control the multiplexer. Make sure to turn the multiplexer power off before setting the DIP switches. MON 2 (88) To set the output at monitor 2, it can be used in combination with the monitor 1 display. [. . . ]