User manual SANYO NVM-4370

[. . . ] INSTRUCTION MANUAL NVM-4370 Portable Navigation System If you need assistance with product operation, authorized service center referral, service assistance, problem resolution, or parts and accessories availability; you may contact us by: A. Visiting www. sanyoservice. com on a 24hr/7 days a week basis or B. calling the customer support center at 1-800-421-6382 Weekdays 7:30 AM - 5:00 PM Pacific Time FCC COMPLIANCE * This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. [. . . ] Figure 5: Windshield & Dashboard Car Mounting kit 1 2 6 3 4 5 Table 5: The components of Windshield & Dashboard Car Mounting kit No. 1 2 3 4 5 6 Function Adjustable 2 prong ratching plate Tower unit Suction cup locking lever Suction cup Suction cup release tab Dashboard Mounting Disc Description Connects the device to the ratching plate which can be adjustable horizontally and vertically. Allows the device to be adjusted in 360° Secures the vacuum seal of the car mount. Fixes the car mount to the selected mounting area. Pull to release the vacuum seal of the suction cup. For Dashboard mounting usage 14 Using the car Mounting kit 1. Clean and dry the mounting surface with a clean cotton cloth. If the ambient temperature is below +60°F (15°C), you can warm the mounting area and the suction cup (e. g. with a hair dryer) to ensure a strong suction bond. Install the car mount on the selected area. Fix the suction cup to the selected area with the locking lever facing up for easier access. Flip the locking lever away from you to create a vacuum between the suction cup and the window surface. On the Dashboard Warning: The permanent mounting adhesive is extremely difficult to remove after it is installed. a. Remove the backing from the permanent mounting adhesive on the bottom of the disc and place the mounting disc on the dashboard. b. Fix the suction cup to top of the mounting disc with the locking lever facing up for easier access. c. Flip the locking lever away from you to create a vacuum between the suction cup and the mounting disc. Make sure that the suction is strong and stable before proceeding to the next step. After you are sure the mounting bracket is safe and secure, attach and slide your unit into its ratching plate. It snaps in easily with the quick release connectors. Adjust the car mount for the best viewing angle. Connect the car adaptor into the cigarette lighter receptacle. The car adaptor LED indicator will glow when powered. [. . . ] If your device still does not respond after performing "reset", disconnect all cables, including the Car adaptor, from your device. Slide the battery ON/OFF switch on the bottom of the device to the OFF (left) position. Then slide it to the ON position again. 6. 4 · Users can also perform a "system reset. " To do a "system reset" in the Main Menu, tap the Settings, then tap the Sys Info. This will allow you to do a factory reset (restore to default settings), reset the GPS and recalibrate the touchscreen interface. 6. 5 · · Screen is not displayed normally. Make sure that brightness setting is appropriate. [. . . ]