User manual SANYO PLC-XP18N

[. . . ] Multimedia Projector MODEL PLC-XP21N PLC-XP18N Owner's Manual INFORMATION TO THE USER NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause har mful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. TO THE OWNER As the owner of a new Multi-media Projector, you are probably eager to try out your new projector. [. . . ] Move the arrow to Yes and then press the SELECT BUTTON. You can adjust the settings again if needed. NOTE : "TINT" will be skipped in the PAL, SECAM, PAL-M and PAL-N mode. MAIN MENU DISPLAY IMAGE ADJUST DISPLAY PROGRESSIVE Set "On" to provide progressive scan mode. NOTE: The Progressive cannot be operated when "Y, Pb, Pr" is selected on the VIDEO SOURCE SELECT menu. (See page 33) Press the SELECT button to set the function "On" or "Off". TABLE OF PICTURE IMAGE ADJUSTMENT COLOR TINT WHITE BALANCE (R/G/B) CONTRAST BRIGHTNESS SHARPNESS DECREASES MORE PURPLE DECREASES LIGHTER DARKER SOFTER 0 0 0 0 0 0 63 INCREASES 63 MORE GREEN 63 INCREASES 63 DEEPER 63 BRIGHTER 31 SHARPER 34 VIDEO MODE PICTURE SCREEN ADJUSTMENT This projector has a picture screen resize function, which enables you to display the image in desirable size. WIDE function This projector is able to project not only a normal video image (with 4 x 3 aspect ratio), but also a wider video image by compressing 4 x 3 image. This feature enable you to enjoy watching pictures like cinema images. You can switch either to WIDE or to REGULAR screen mode. Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear. Press the POINT LEFT/RIGHT BUTTON(s) to select SCREEN and press the SELECT BUTTON. Another dialog box SCREEN ADJUST DISPLAY will appear. Press the POINT DOWN BUTTON and a red arrow will appear. To switch to "Wide" mode, move the arrow to Wide by pressing the POINT UP/DOWN BUTTON(s) and then press the SELECT BUTTON. To switch to "Regular" mode, move the arrow to Regular by pressing the POINT UP/DOWN BUTTON(s) and then press the SELECT BUTTON. When the image is distorted vertically, move the arrow to Keystone by pressing POINT UP/DOWN BUTTON(s) and then press SELECT BUTTON. The "Keystone" is displayed to indicate Keystone mode. Press the POINT UP BUTTON to reduce the upper part of the image, and the POINT DOWN BUTTON to reduce the lower part. (See "KEYSTONE FUNCTION" section on page 28). Press the NORMAL BUTTON in keystone mode, the image changed to original image (not correct keystone distortion). NOTE: The "WIDE" function cannot be operated when "Y, Pb, Pr" (except 480p) is selected on the VIDEO SOURCE SELECT menu. [. . . ] Press the MUTE button. Some displays are not seen during the operation. No sound. Remote control unit does not work. q Check the batteries. q Make sure nothing is blocking between the remote control sensor and remote control unit. q Make sure you are not too far from the projector when using the remote control unit. [. . . ]