User manual SANYO PLC5600N

[. . . ] If your projector seems to operate improperly, read this manual again, check operations and cable connections and try the solutions in the "TROUBLESHOOTING" section at the end of this booklet. If the problem still persists, contact the sales dealer where you purchased the projector or the service center. SAFETY PRECAUTIONS WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. q This projector produces intense light from the projection lens. Do not stare directly into the lens as possible. [. . . ] If projector cannot reproduce proper image, select correct input source through MENU OPERATION (see below). INPUT button Computer 1 Computer 2 Video INPUT MENU MENU OPERATION When connect the output (Analog) from computer to Computer 1 (HDB 15-pin) terminal on the projector. 1 2 3 Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button to move a red frame pointer to INPUT Menu icon. Press POINT DOWN button to move a red arrow pointer to Computer 1 and then press SELECT button. Press POINT DOWN button and a red-arrow icon will appear. Move arrow to "RGB" and press SELECT button. When computer is connected to Computer 1, select RGB. When video equipment is connected to Computer 1 terminal, select RGB (Scart). Refer to P31. Computer 1 INPUT Menu icon Move a pointer (red arrow) to Computer 1 and press SELECT button. RGB RGB (Scart) Source Select Menu Move a pointer to RGB and press SELECT button. When connect the output (Digital/Analog) from computer to Computer 2 (DVI-I) terminal on the projector. INPUT MENU 1 2 3 Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button to move a red frame pointer to INPUT Menu icon. Press POINT DOWN button to move a red arrow pointer to Computer 2 and then press SELECT button. Auto PC Adj. 1 2 Press MENU button and ON-SCREEN MENU will appear. Press POINT LEFT/RIGHT button to move a red frame pointer to PC ADJUST Menu icon. Press POINT DOWN button to move a red frame pointer to AUTO PC Adj. icon and then press SELECT button twice. This Auto PC Adjustment can be also executed by pressing AUTO PC ADJ. button on Top Control or on Remote Control Unit. PC ADJUST MENU PC ADJUST Menu icon Move a red frame pointer to AUTO PC Adj. icon and press SELECT button. Store adjustment parameters. Adjustment parameters from Auto PC Adjustment can be memorized in this projector. Once parameters are memorized, the setting can be done just by selecting Mode in PC SYSTEM Menu (P23). Refer to step 3 of MANUAL PC ADJUSTMENT section (P27). NOTE q Fine sync, Total dots and Picture Position of some computers can not be fully adjusted with this Auto PC Adjustment function. When the image is not provided properly through this function, manual adjustments are required. [. . . ] Make sure you are not too far from a projector when using Remote Control Unit. Maximum operating range is 16. 4' (5m). q Make sure the code of Remote Control Unit is set to conform to projector. (See "SETTING" section on page 36, 37. ) q Check cable connection between a projector and your computer. [. . . ]