User manual SANYO PLCSU60

[. . . ] Before you do, we suggest that your spend a little time reading this manual to familiarize yourself with the operating procedures, so that you will receive maximum satisfaction from the many features included in your new projector. This owner's manual will acquaint you with your projector's features. Through the years, we have found that many service requests were not caused by problems with our projectors. They were caused by problems that could have been prevented, if the owner had followed the instructions in the manual. [. . . ] Move the arrow to the item that you want to select by pressing the POINT UP/DOWN buttons. Move the arrow to v or w of "Volume" by pressing the POINT UP/ DOWN buttons. To increase the volume, point the arrow to v and then press the SELECT button. To decrease the volume point the arrow to w and then press the SELECT button. To cut off the audio sound, point the arrow to "Mute" and then press the SELECT button. The Mute display is changed On from Off and the sound is cut off. To restore the sound to its previous volume level, set the Mute to Off. It indicates the roughly level of the item. Move the arrow to the item and then press the SELECT button. Move the arrow to v or w and press the SELECT button. Volume Mute It closes the Sound Menu. 23 COMPUTER MODE SELECTING COMPUTER MODE Direct Operation Press the MODE button on the Top Control or the Remote Control Unit. The input source is selected among COMPUTER or VIDEO. The "Computer" or "Video" display will appear on the screen for a few seconds. In this dialog box, you can store the parameter into the area from "Mode 1" to "Mode 8. " When memorizing the new computer parameter, select the Mode with the message of "Free" by pressing the POINT UP/DOWN buttons and SELECT button. To change the parameters of the Mode previously set, select the Mode with "Stored. " When the Mode is selected, Parameter adjustment dialog box appears. Adjust the each item to match with your computer. The number of the total vertical lines. Adjust the number to match your PC image. The number of the total dots in one horizontal period. Adjust the number to match your PC image. Adjustment of the horizontal picture position. When the image is not centered on the screen, adjust this item. Adjustment of the vertical picture position. When the image is not centered on the screen, adjust this item. When the image has a dark bar(s), try this adjustment. [. . . ] q Check audio cable connection from audio input source. q Press MUTE button. No sound. 36 APPENDIX Problem: Remote Control Unit does not work. Try these Solution q Check the batteries. q Make sure anything is blocking between the Remote Receiver and the Remote Control Unit. q Make sure you are not too far from the projector when using the Remote Control Unit. [. . . ]