User manual SANYO PLCXR70N

[. . . ] Multimedia Rear-Projection Display MODEL PLC-XR70N , , , , , , , , , , , , , , , , , , , , , , , , Owner's Manual INFORMATION TO THE USER NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause har mful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. TO THE OWNER As the owner of a new Rear-Projection Display, you are probably eager to try out your new projector. [. . . ] Adjust and set the computer system manually. (Refer to PC ADJUSTMENT on page 28. ) There is no signal from the computer on the any terminal (the Rear Terminal or the Front Terminal). Make sure the connection of the computer and the projector is set correctly. (Refer to TROUBLESHOOTING on page 43. ) VGA 1 SYSTEM BOX It displays the SYSTEM being selected. No signal Selecting Computer System Manually To set the Computer system manually, select the Mode from the COMPUTER SYSTEM Menu on the ON-SCREEN MENU. The system being selected. 1 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select SYSTEM and press the SELECT (REAR CLICK) button. Another dialog box COMPUTER MODE Menu will appear. (The COMPUTER MODE Menu also appears by pressing the SYSTEM button on the Front Control or the Remote Control Units. ) Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to the system that you want to set, and then press SELECT (REAR CLICK) button. VGA 1 VGA 1 VGA 2 VGA 3 MODE 1 MODE 2 The system on this dialog box can be selected. 2 It terminates the SYSTEM Menu. When this mark is displayed as black, more computer system modes will be available. Move the arrow to this mark and then press the SELECT (REAR CLICK) button, and another mode will be displayed. 27 COMPUTER MODE PC ADJUSTMENT This Projector can automatically detect display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be detected by this projector. If this happens, the projector cannot reproduce a proper image and the image is recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture. This projector has PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match with the input signal format. The projector has eight independent memory areas where you can store the parameter you have set. This enables you to recall the setting for a specific computer whenever you need it. 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT LEFT/RIGHT buttons to select PC ADJUST and press the SELECT (REAR CLICK) button. Another dialog box "Where to reserve" Menu will appear. In this dialog box, you can store the parameter into the area from "Mode 1" to "Mode 8. " When memorizing the new computer parameter, select the Mode with the message of "Free" by pressing the POINT UP/DOWN buttons and SELECT button. To change the parameters of the Mode previously set, select the Mode with "Stored. " When the Mode is selected, Parameter adjustment dialog box appears. Adjust the each item to match with your computer. Total lines Total dots Horizontal Vertical Clamp Height Width The number of the total vertical lines. Adjust the number to match your PC image. The number of the total dots in one horizontal period. [. . . ] Maximum operating range is 16. 4 feet (5m). l Check the cable connection between the projector and the computer. l Check the mouse setting on your computer. l Turn the projector before your turn on the computer. No sound. Remote Control Units dose not work. [. . . ]