User manual SANYO PLV30

[. . . ] Multimedia Projector MODEL PLV-30 Owner's Manual TO THE OWNER Before operating this projector, read this manual thoroughly and operate the projector properly. This projector provides many convenient features and functions. Operating the projector properly enables you to manage those features and maintains it in better condition for a considerable time. Improper operation may result in not only shortening the product-life, but also malfunctions, fire hazard, or other accidents. [. . . ] Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to the system that you want to set, and then press SELECT button. The systems on these dialog boxes can be selected. Closes the SYSTEM Menu. 21 COMPUTER MODE PC ADJUSTMENT This Projector can automatically tune to the display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be tuned by the Multi-Scan system of this projector. If this happens, the projector cannot reproduce a proper image and the image may be recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture. This projector has a PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match with those special signal formats. This projector has five independent memory areas to memorize those parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use it. Note : This PC ADJUSTMENT function cannot be operated when "RGB, " "HDTV1035i" or "HDTV1080i" is selected on the SYSTEM MENU (P21). 1 2 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT RIGHT/LEFT buttons to select PC ADJUST and press the SELECT button. Another dialog box "Where to reserve" Menu will appear. In this dialog box, you can store the parameter into the area from "Mode 1" to "Mode 5. " When memorizing the new computer parameter, select the Mode with the message "Free" by pressing the POINT UP/DOWN buttons and the SELECT button. To change the parameters of the Mode previously set, select the Mode with "Stored. " When the Mode is selected, Parameter adjustment dialog box appears. Move the arrow to the item that you want to change by pressing the POINT UP/DOWN buttons, and adjust each item to match with your computer. To change the value, press either the POINT RIGHT / LEFT button. Refer to the next page for adjusting each item. Move the arrow to "Stored" and press the SELECT button. The parameter is memorized in the selected Mode. To activate the Mode manually adjusted in this PC ADJUSTMENT Menu, select the Mode at the SYSTEM SELECT Menu. (Refer to page 21. ) This Mode has parameters being stored. The Vacant Mode. 3 Manual set Computer Mode (1 to 5). Closes the PC ADJUSTMENT Menu. 4 5 Press the SELECT button to set Full screen function on/off. Press the POINT RIGHT/LEFT buttons to adjust the value. 22 COMPUTER MODE Total lines The number of the total vertical lines. Adjust the number to match the image of your personal computer. [. . . ] q Check the projection lens to see if it needs cleaning. NOTE : Moving the projector from a cool temperature location to a warm temperature location may result in moisture condensation on the lens. In such an event, leave the projector OFF and wait until condensation disappears. (See "SETTING" section on page 32. ) q Check Ceiling feature. [. . . ]