User manual SANYO POA-PN02C

[. . . ] POA-PN02C PJ-Net Organizer plus C OWNER'S MANUAL PLV-80/75 Series DC OUT CONTROL PORT VIDEO IN LIN K ACT Compliance Federal Communication Commission Notice This equipment has been tested and found to comply SANYO POA-PN02C with the limits for a Class B digital device, pursuant to Tested To Comply part 15 of the FCC Rules. These limits are designed to With FCC Standards provide reasonable protection against harmful interference in a residential installation. This equipment generFOR HOME OR OFFICE USE ates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] Select a system and then click Set button. Available selection at the RGB(PC analog) input Item Description XGA1 . . . . . . . . . . . . . . . . . . . . . . . . It automatically switches to the proper computer system of the input signal. * The computer system modes (VGA, SVGA, XGA. SXGA, UXGA, WXGA. . . ) which meet the input signal are listed. Available selection at the RGB(PC digital) input Item Description D-XGA. . . . . . . . . . . . . . . . . . . . . . It automatically switches to the proper computer system of the input signal. * The computer system modes (D-VGA, D-SVGA, D-XGA. D-SXGA1. . . ) which meet the input signal are listed. Available selection at the Video/S-video/Scart input Item Description AUTO . . . . . . . . . . . . . . . . . . . . . . . . It automatically switches to the proper color system of the input signal. * The selectable color systems are PAL, SECAM, NTSC, NTSC4. 43, PAL-M and PAL-N. * AUTO is fixed at the Scart input. Available selection at the RGB(AV HDCP) input Item Description AUTO . . . . . . . . . . . . . . . . . . . . . . . . It automatically switches to the proper scanning system of the input signal. * The selectable scanning systems are D-480p, D-575p, D-720p, D-1035i and D-1080i. Available selection at the Y, Pb/Cb, Pr/Cr input Item Description AUTO . . . . . . . . . . . . . . . . . . . . . . . . It automatically switches to the proper scanning system of the input signal. * The selectable scanning systems are 480i, 575i, 480p, 575p, 720p, 1035i and 1080i. If the mode (Mode1 to Mode 10, ExMode11 to ExMode50) which is stored in the item "PC Adjustment" (+ p. 48) is available, they are also listed together with the above mode. PJ-NET ORGANIZER OWNER'S MANUAL [PLV-80/75 Series] ENGLISH Chapter 4 Controlling the Projector Image adjustment This function is to adjust the projected picture image and save the image mode. To store the adjusted value, click Store button, and to load the adjusted value, click Load button. Item Description Contrast . . . . . . . . . . . . . . . . . Adjusts picture contrast (0~ 63) Brightness . . . . . . . . . . . . Adjusts picture brightness (0~ 63) Color . . . . . . . . . . . . . . . . . . . . . . . . . Adjusts picture color saturation (0~ 63) Tint . . . . . . . . . . . . . . . . . . . . . . . . . . . . Adjusts picture hue (0~ 63) Item Description Color Temp. (X Low, Low, Mid, High, Adj. ) White Balance Red, Green, Blue. . . . . . . . . . . . . . . . . . . . . Adjusts each white balance respectively. (0~ 63) Sharpness . . . . . . . . . . . . . Adjusts picture sharpness. (0~ 31) * When changing the value of the white balance, the color temp. indicates "Adj. " Item Description Gamma. . . . . . . . . . . . . . . . . . . . . . Adjusts brightness of darker part of the picture. [. . . ] If the SMTP server is located in your LAN (Local Area network), the address should be set to the SMTP server in your LAN. The SMTP server located outside of your LAN may not be available for security reason. For further information please contact your network administrator (+ p. 34). It may be required for the authentication depending on the SMTP server. [. . . ]