User manual SANYO SC-X1801

[. . . ] Children should be supervised to ensure that they do not play with the appliance. These appliances (SC-X1801 and Handy Cleaner SC-H24) are not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Do not handle plug or appliance with wet hands. Hold plug when they rewinding onto cord reel. [. . . ] Connect the tube to the curved end of the hose. Connect the different tools to the tube for different cleaning purposes; Floor brush (adjusted to the type of ground) for carpet or floor. Combination nozzle for sofa, wall surface, curtain, corner or space between furniture etc. Before starting operation, pull out the power cord and then insert the plug into the power socket which conforms to that on the rating label for power supply. Press the on/off switch pedal, the machine could start working. The machine would start working without speed control. To control suction power, slide the speed control on the body. Suction power can also be controlled by sliding the airflow control on the hose. Combination nozzle; Use the crevice nozzle on vacuum edges and gaps. The head of the combination nozzle can rotate. Use the round brush to vacuum sofa, curtain or fragile or easily scratched items. Turn off the machine: press the on/off switch pedal again, the machine is turned off. Cord rewinding; Before rewinding, be sure to the cord is unplugged. To rewind the power cord, press the cord rewinding pedal, the power cord will be drawn in. Remove the hose accessories; press the adaptors at both side of the hose end and then pull the hose accessories. Figure_8 4 Attention: To lock the front cover firmly, snick it softly until it sounds "Click" If the blockage is found in floor brush, hose or tubes and the machine, the machine can be re-operated only after the blockage is cleaned away completely. This vacuum cleaner can be used as tip the rubbish out of the full dust cup. Figure_1 Figure_2 Figure_3 Figure_4 Figure_5 Figure_6 Figure_7 Figure_8 Maintenance CAUTION Be sure to turn the power off and unplug the unit before cleaning. Clear the dust: when the dust collect to the MAX label of the filter, rubbish shall be tipped from the dust barrel. 1) Press the front cover clip beside the suction socket and open the front cover. 2) Take out the dust cup and clean the dust away completely. 3) Clean the dust cup with warm water if necessary. 5 2. Clean Filters: HEPA filter; 1) Open the front cover: Press the buttons at the both side of socket hole and open it slowly. Figure_9, Figure_10 2) Dump the dust collection out of the dust cup. [. . . ] To remove the filter, removing the dirt. If the dust is packed tightly and difficult to remove, tap the dust compartment lightly. 3. Insert the filter to the dust box. Dust box Filter 4. To reassemble the unit If the dust box can not be closed, the filter is not properly installed. Dust box 9 Care of filter: A severely soiled or clogged filter should be thoroughly washed with fresh tepid water. [. . . ]