User manual SANYO SCB550

[. . . ] Hold the floor nozzle away from the floor, while operating to check. Connect the angled pipe DUST INDICATOR DUST INDICATOR (When the pipe wouldn't expand / contract) Pull the pipe up hard. Button Pull Vacuum power adjustment ring Vacuuming can continue. Insert securely by turning Caution Please do not place your hand on the extension pipe buttons during operation. Please do push the button in when adjusting the length. Dust compartment should be emptied. Power Control / ( SC-B555/B555T only / SC-B555/B555T ( Angled pipe Set the POWER CONTROL to MAX for maximum suction. In the position MIN the suction power is decreased. MAX POWER CONTROL MIN Removal ring / SC-B555T only / TURBO CLEANTM / SC-B555T Hose stopper Button Pipe holder Hose Handle Switch / Start or stop vacuum cleaner by pushing on the switch. Change the switch lever according to the area you want to vacuum. High Air inlet Blower (Exhaust outlet) / Use blower to blow dust behind furniture, etc. [. . . ] Caution: If the dust is packed tightly and difficult to remove, lightly tap the dust compartment. 4. Slide the lever in the direction of the arrows to remove the dust by shaking. Lever 5. Hold the clamp to open up the pre-filter and empty the dirt out of the filter. Insert the filter in the dust compartment. Then attach the dust compartment section to the motor section. Thank you for your purchase of the Sanyo Vacuum Cleaner. Please read these instructions carefully before using. A FEW PRECAUTIONS 1. Operation without the dust compartment and /or filters in place will allow dust to enter the motor and could damage the vacuum cleaner. Keep the vacuum cleaner away from stoves and other heat sources. Heat can deform and discolor the plastic parts of the unit. Keep the vacuum cleaner free of insecticides. Do not wipe with benzine, thinner, petrol or other oils which might cause discoloration or cracking. To clean the body and hose, dampen a cloth with a mild detergent and wipe clean. Blocking the suction inlet or allowing the dust to clog the hose will decrease the efficiency of the motor. Be sure not to push the clamp button while carrying the vacuum cleaner. Never try to vacuum the following objects. They may damage the unit or cause a fire. * Wet things, mud, soil, and fluids * Burning cigarettes * Needles and razor blades * Inflammable materials such as gasoline and thinner * Construction rubbish 7. The following kinds of treatment shorten hose life: * Bending hose at an acute angle when storing * Pulling the hose with excessive force * Placing heavy objects on, or stepping on the hose 8. Pull out the plug from the power source after use. Grasp the plug not the cord when pulling out the plug. Pulling on the cord may lead to shortcircuiting. Long and continuous use causes the exhaust air and the body of the vacuum cleaner to become warm. [. . . ] Lightly tap the filter to remove the dust. If you are concerned about dust on the filter: 1. If the dust is not easily removed, use a brush for removal. 2. Caution: Do not dry in direct sunlight or by heating, as the filter may become damage. Never put the filter into the vacuum cleaner unless it is completely dry. To assure the best results, we recommend cleaning the filters once every one (1) year, depending on usage. CARE OF TURBO CLEANTM / Before caring for the TURBO CLEANTM , be sure to turn OFF the switch of the unit and disconnect the plug from the outlet. [. . . ]