User manual SANYO SCP-5400

[. . . ] . 4 Section 2: Understanding Your PCS Phone . . 10 Features of Your PCS Vision Ready Link Phone RL2500 . . 19 Adjusting Volume During a Conversation . . 19 Missed Call Notification for Voice Calls . [. . . ] Select Find/Add Entry and press Press on the Navigation key for the shortcut (steps 1 through 3). Highlight the entry to which you wish to add phone numbers or email/Web addresses and press . Highlight a phone number, press Options (right softkey), highlight Edit, and press . ­ or ­ Highlight an email address or Web address, and press Edit (right softkey). Highlight the label field you want to add and press 7. Enter the number or address and press 8. . Editing a Contacts Entry To make changes to an entry: 1. Highlight the entry you wish to edit and press 3. Highlight a phone number, press Options (right softkey), highlight Edit, and press . ­ or ­ Highlight an email address or Web address and press Edit (right softkey). Select the label field you want to edit and press 5. Edit the entry by using your keypad and press 6. Press Save (left softkey) to save your changes. Tip: You can also store the phone number in the Pager, Data, and Fax Category. . Section 2: Understanding Your PCS Phone 2G: Using the Contacts Directory 94 Selecting a Ringer/Image Type for an Entry You can assign a ringer/image type to a Contacts entry so you can identify the caller by the ringer or image type. (See "Ringer Types" on page 43. ) To select a ringer/image type for an entry: 1. Select the entry for which you want to set the incoming ringer or image and press . Highlight a phone number and press Options (right softkey), highlight Edit, and press . ­ or ­ Highlight an Email address or Web address, and press Edit (right softkey). Select the menu under Ringer or Image by scrolling up or down and press . Highlight your desired ringer type or image and press . Ringer & Voice to notify you with Ringer and Voice. [. . . ] Transfer or resale of a Product will automatically terminate warranty coverage with respect to the Products. This limited warranty dose not cover and is void with respect to the following: (i) Products which have been improperly installed, repaired, maintained or modified (including the antenna); (ii) Products which have been subjected to misuse (including Products used in conjunction with hardware electrically or mechanically incompatible or used with accessories not supplied by Sprint), abuse accident, physical damage, abnormal operation, improper handling and storage, neglect, exposure to fire, water or excessive moisture or dampness or extreme changes in climate or temperature, (iii) Products operated outside published maximum ratings; (iv) cosmetic damage; (v) Products on which warranty stickers or Product serial numbers have been removed, altered, or rendered illegible; (vi) customer instruction; (vii) cost of installation, removal or reinstallation; (viii) signal reception problems (unless caused by defect in material and workmanship); (ix) damage the result of fire, flood, acts of God or other acts which are not the fault of Sprint and which the Product is not specified to tolerate, including damage caused by mishandling and blown fuses; (x) consumables (such as fuses); or (xi) any Products which have been opened, repaired, modified or altered by anyone other than Sprint or a Sprint authorized service center. Section 4: Safety Guidelines and Warranty Information 4B: Warranty 188 This warranty does not cover customer education, instruction, installation, set up adjustments, or signal reception problems. This warranty is valid only in the United States. USE WITH ACCESSORIES NOT SUPPLIED BY SPRINT OR OTHERWISE NOT EXPRESSLY AUTHORIZED BY SPRINT MAY BE DANGEROUS. [. . . ]