User manual SANYO SCX1000P

[. . . ] Caution Remove the adapter from the wall socket before you clean the charger. Only charge the vacuum cleaner with the adapter and charger supplied. During charging, the adapter feels warm to the touch. Always switch off the vacuum cleaner after use. [. . . ] 4) 3 Slide the brush tool onto the crevice tool and place them in the charger (Fig. 4 SCX1000P only: insert the telescopic stick and the floor nozzle into the nozzle & stick holder (`click') (Fig. Charging the appliance Caution: Make sure the appliance is switched off when you charge it. Charge the appliance for at least 18 hours before you use it for the first time. Tip: If you are not going to use the appliance for a longer period of time, remove the adapter from the wall socket to save energy. Note:The charging light stays on as long as the appliance is placed on the charger and the adapter is in the wall socket. 1 Charge the appliance in one of the following two ways: Insert the small plug into the charger, insert the adapter into the wall socket, and place the appliance on the charger (Fig. - Insert the small plug into the charging socket of the appliance and insert the adapter into the wall socket (Fig. , The charging light on the appliance goes on to indicate that the appliance is charging (Fig. Note:The charging light does not give any information about the charge level of the built-in battery pack. 11) 3 Leave the adapter in the wall socket and always put the vacuum cleaner back onto the charger after use, even if the battery pack is still almost fully charged. We advise you to clean the filters every 2 to 4 weeks to maintain optimal suction performance. Quick cleaning To empty the dust compartment quickly: 1 Press the nozzle release button to remove the detachable nozzle (Fig. Thorough cleaning To clean the dust compartment and the filter unit thoroughly: 1 Hold the appliance over a dustbin, press the dust compartment release button (1) and remove the dust compartment (2). 3 Shake the dust compartment out with your free hand to empty it. 4 Turn the outer filter anticlockwise to remove it from the filter holder and clean the filter (Fig. 5 Gently turn the inner HEPA filter anticlockwise to remove it from the filter holder (Fig. 25) Brush the inner HEPA filter from the top downwards along the ribs of the filter. , If necessary, you can clean the outer filter and the inner HEPA filter in cold or lukewarm water. 8 Place the outer filter back onto the filter holder and turn it clockwise to fasten it (Fig. Never put the filter unit back into the dust compartment when the outer filter and inner filter are still wet. 10 To clean the detachable nozzle, press the nozzle release button to remove the detachable nozzle from the appliance (Fig. [. . . ] The built-in rechargeable battery pack contains substances that may pollute the environment. Always remove the battery pack before you discard and hand in the appliance at an official collection point. dispose of the battery pack at an official collection point for batteries. If you have trouble removing the battery pack, you can also take the appliance to a Philips service centre. [. . . ]