User manual SANYO SLIM-1400

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. Increase the distance between the equipment and the receiver. [. . . ] It will make unexpected error or image damaged. Inserting an SD/SDHC Memory Card English 18 Camera Setup Charging the Battery 1. Insert the battery into the camera and connect the DC power supply cable with the power adapter as shown in the picture. 3X OPTICA L ZOOM ON / OFF Connect the power adapter to a live household outlet to start charging. The power LED will blink during the charging process. Disconnect the DC power supply cable when the charging is done. When the charging is done, Power LED turns off. English 3. Charging the Battery with USB power 1. Turn the power off and connect the USB cable with the camera and the computer. The power LED will blink during the charging process. The power LED will turn off automatically when the charging is done. The room temperature suitable for charging the camera is 6 °C~36 °C. Power LED blinks during the charge and turns off automatically after the charge. The battery does not charge when room temperature exceeds 36 °C or falls below 6 °C. The battery does not charge again automatically even when the temperature comes back to 6 °C~36 °C, once the charge stops by higher or lower temperature. The multi-burst photography feature allows you to take multiple (16) consecutive VGA photos by pressing the Shutter button once. Press the Right/Self-timer /Burst mode navigation button to cycle through the self- English timer( or ) and burst photography options ( or ) on the LCD screen. Once you have selected an option, frame and take your shot. In self-timer mode, the icon will flash until the time expires and the photo is taken. After taking a photo, the Self-timer automatically exit. If you want to use these functions for the next photo, press the Right/Self-timer function. /Burst mode navigation button again to activate the Note: : Burst Mode Up to 2 photos by pressing the shutter button continuously. : Multi-Burst Mode 16 photos continuously by 1 press of the Shutter button. Taking your First Photo Getting Started 23 Setting the Scene Mode The camera supports various preset modes for shooting in different environments and conditions. Each setting is configured automatically by the camera. To select scene modes: Auto P-Mode Portrait Night Portrait Landscape · · · · · · · · · · · · · · · 2. Auto P-Mode Portrait Night Portrait Landscape Sport Night Landscape Backlight Museum Snow Sunset Fireworks Party Beach Copy · Video Press OK to confirm your selection. Taking your First Photo English Press the SCENE button to access ( ) SCENE menu which displays the Scene menu options. [. . . ] Once selected, the Reset Camera screen displays a confirmation message. Select EXIT(default) to cancel or YES to proceed with the Reset and press the OK button to confirm. RESET CAMERA Reset to camera default setting?EXIT YES English Voice Memo The Voice Memo setting allows you to record a voice memo when a photo is taken. Select ON to enable the Voice Memo function or OFF (default) to disable it. VOICE MEMO ON OFF About The About screen allows you to check the current firmware version of the camera. ABOUT FW VERSION : 1. 0040 The Setup Menu Camera Settings 49 PictBridge Print (PTP) The PTP function allows you to print images captured by the camera directly without connecting the camera to a PC. [. . . ]