User manual SANYO TVQ-EXA089K INSTALLATION AND SERVICE MANUAL

[. . . ] 8 CASE LEVELING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 JOINING INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Applying gasket (for connecting cases or installing side panels). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Connecting cases (8-ft and 12-ft cases) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Products described in this manual are designed for indoor use only. Products should not be exposed to direct sunlight. Fan motors are available in standard-type (AC fan motors) or high-efficiency type (DC fan motors). 5 Waste Outlet Electrical Field Connection Refrigeration Outlet 2 Dimensions 2. 1 * Dimensions given in inches and millimeters (mm in parentheses). External Dimensions 2. 2 Footprint (8-, 12-ft models) (End Case) 6 3 Unloading and Carpentry Procedures 3. 1 NSF Certification The merchandisers described in this manual are built to meet the requirements of American National Standard/NSF International Standard 7. Each merchandiser bears a nameplate identifying the type of application for which it was certified: Type I display refrigerator / freezer: Intended for use in an area where the environmental conditions are controlled and maintained so that the ambient temperature typically does not exceed 75°F. 3. 2 Location As noted above, the merchandisers described in this manual are design for the display of products in interior spaces with climate control, with ambient conditions typically maintained below 75°F and 55% relative humidity. Proper merchandiser performance cannot be guaranteed when ambient temperature and/or humidity exceeds this level. Merchandisers should not be exposed to direct sunlight or other sources of heat. Merchandisers should not be exposed to strong air currents, as these may disrupt the air curtain used to maintain proper temperature inside the merchandiser display area. 3. 3 Shipping Damage All equipment should be examined for shipping damage prior to and during offloading. All equipment goes through outgoing inspection upon leaving our warehouse, and the carrier assumes responsibility for the safe arrival of our merchandisers. APPARENT DAMAGE: Any obvious loss or damage should be noted immediately at the time of receipt on the freight bill or express receipt and signed by the carrier's agent. Failure to do so may lead to rejection of the claim by the carrier. CONCEALED DAMAGE: If damage that is not apparent during unloading is found after unpacking, retain all packing materials and submit a written request to the carrier for inspection within 15 days. LOST ITEMS: Any claims related to lost or missing items must be made to SANYO Commercial Solutions within 48 hours of receipt of equipment. 3. 4 Unloading Instructions & Precautions WARNING Cases are heavy and bulky, and require at least two people for unloading, moving, and installation. 8-ft and 12-ft merchandisers have wooden beams mounted on each side (no beams on end cases). Do not remove the wooden beam from the bottom edges of each case until the cases have been moved into place in the store lineup. Do not walk on the top of the merchandisers. Walking on the top of the merchandiser may lead to serious injury and/or damage to the merchandiser. Do not place other heavy loads on the top of the merchandiser. Recommended Practices for Unloading Merchandisers: 1. Use a J-bar (Johnson bar) to lift one end of the merchandiser. Insert one or more dollies under the base leg. Use dollies on both ends of the merchandiser to move to lineup location after unloading from container. 7 3. 5 Aligning Cases WARNING Cases are heavy and bulky, and require at least two people for unloading, moving, and installation. Do not walk on the top of the merchandisers. [. . . ] You should turn power on and open hand valve ONLY AFTER you have completed cleaning and put parts back in place. 6. 2. 1 Deck Pan Clean the entire deck pan surface, preferably with water only. If required, you may use a mild detergent and warm water to remove stains. You should follow by wiping down with water only in order to prevent discoloration. 6. 2. 2 Drain Trap Check and clean the drain trap at least once a month. You may access the drain trap by removing the deck pans. Remove any material that has gathered in the drain trap and dispose of it. [. . . ]