User manual SANYO VA-SW5000

[. . . ] INSTRUCTION MANUAL VA-SW5000 CCTV Sysytem Management Software CONTENTS FOREWORD . . SETUP BASIC PROCEDURES FOR STARTING UP THE SYSTEM . [REQUIRED SETTINGS FOR NETWORK CONNECTIONS . 9 10 12 MASTER COMPUTER INITIAL SETTINGS . [. . . ] Sets the camera titles to be displayed on the monitor. Assigns the capacities for each recording area and starts recording again when recording has stopped because of a recording area becoming full. Sets overwrite recording operations and sets the standard value for remaining space warning. Sets the recording conditions for normal recording and timer recording. Sets combinations of cameras to be recorded, and sets each individual recording rate. Sets the operating conditions for timer recording. Sets the recording conditions for alarm recording and pre-alarm recording. Sets the display method for images on the monitor while alarm recording is in progress. Sets the alarm detection conditions for the motion sensors that are built into the cameras. Sets the information that is displayed on the monitor. Sets the warning buzzer that sounds when a problem occurs. When operating the system using a system controller, makes the interface settings at the DVR. Displays the hard disk recording capacity, initializes the hard disk and sets mirroring. Displays the security lock setting details. (Limited to DSR-5009P, DSR-5016 and DSR-5016P only) Sets conditions for network connections and [PASSWORD] settings for logging in. Sets the conditions for network control. Sets the [USER ID], [PASSWORD] and operating user levels at the DVRs. 1 [INITIAL SET] [RECORDING SET] [GENERAL SET] 2 3 4 5 6 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 English ­ 63 ­ SETTING DVR OPERATING CONDITIONS b [DVR INFO SETUP] menu (continued) Menu 1 [DISPLAY SET] 2 3 4 5 [MULTI SCREEN SET] [SEQUENCE SET] [MAIN MONITOR/MONITOR2 SET] [MASK SET] [COLOR LEVEL SET] Contents Sets the display positions for images from each channel in the monitor's multi screen display. Sets automatic mode for switching channel images. Sets the channel for automatic switching based on clock cycle settings. Sets specified channels that are being monitored or played back so that the images from those channels cannot be seen. Sets the monitor color levels for each channel. Displays DVR information such as power failure time, operating time and firmware version. [. . . ] (P. 71 ­ 72) q q English ­ 115 ­ DOWNLOAD INFORMATION MANAGEMENT AND AUTOMATIC MODE SETTINGS a Adding a new download pattern When you click download pattern registration list. , the [DOWNLOAD PATTERN SET] dialog box will be displayed. A new download pattern will be registered and it will be added to the pattern for each item and then click 1 [PATTERN NAME] (Required item) Enter the pattern name for system management. (Double-byte characters can also be entered. ) q q An error message will be displayed if the pattern name has already been used. [. . . ]