User manual SANYO VPC-CA102YL

[. . . ] INSTRUCTION MANUAL Dual Camera VPC-CA100EX VPC-CA100GX VPC-CA100PX VPC-CA100TA VPC-CA102 Important note This manual explains how to safely operate the VPC-CA100EX, VPC-CA100GX, VPC-CA100PX, VPC-CA100TA and VPC-CA102. Any information regarding only one of these products will be labeled as such. Please read these instructions carefully before using the camera. Make sure to read and understand the separate booklet “SAFETY MANUAL”. [. . . ] I If the digital zoom (page 67) is being used, the large magnification factor may make it difficult for the motion compensation function to work correctly. I When the scene select function is set to night view portrait / or lamp Q, the motion compensation effect may be insignificant. can’t set the “photo stabilizer” setting?I The photo stabilizer is automatically turned off ] after any of the following operations. H Setting the camera to the sequential shots mode (pages 46 and 85). When motion compensation is enabled, i The following icons are shown on the monitor: NORMAL/SHOOTING 001:00:05 The video stabilizer is active The photo stabilizer is active Both the video stabilizer and the photo stabilizer are active Did the scene select setting change?I When the photo stabilizer is set to \, if the scene select setting is +, it will automatically change to =. Full-HD English 88 Focus range setting How to use the manual focus 1 Select -, and press the SET button. h The focus distance adjustment bar appears. Press [G] or [H] to adjust the focus distance, and press the SET button. H The focus distance is set, and you are returned to the Recording Screen. 7112 14M-S 001:00:05 Full-HD 2 2. 0m HINT About the focus range i The focus distance indication shows the distance between the center of the lens and the subject. I In some cases there may be a slight variance between the distance (numerical figure) you set in the manual focus mode and the actual distance. About zoom movement when using the manual focus i If the focus distance is set to 70 cm (27. ) or less, the zoom changes to the largest setting that is suitable for that focus distance. I When the focus distance is set to 70 cm (27. ) or less, the zoom will function only within the range at which the image is focused. About the super macro mode i When the focus range is set to super macro +, the zoom is temporarily set to the wide end. I By assigning an operation shortcut to an arrow key (pages 122 and 125), you can change the focus range setting from the Recording Screen. 89 English Focus mode setting When the spot focus setting is selected, the focus mark + appears in the center of the monitor. 7112 14M-S 001:00:05 Full-HD Focus mark NORMAL/SHOOTING Light-measuring mode setting When spot light-measuring is selected, the light-measuring spot mark appears in the center of the monitor. [. . . ] NOTE i If the background is distracting, it will not show your subject to his best advantage. Move in closer to your subject or zoom in so that the background does not compete with the subject. I In portrait photography your subject is clearly the central figure, so try techniques that allow the subject to stand out. I If light is coming from behind your subject (backlit), his face will appear dark. [. . . ]