User manual SANYO VPC-S600

[. . . ] FCC STATEMENT (For customers in USA) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Press the power switch to turn on the power. Press the four-way controller ( / Capture Mode Captu e Mod pture self-timer mode. You can also change the setting using four-way controller 2 sec. Press the button to confirm the setting. Compose your scene and press the shutter release button. The photograph is then taken after the preset time. ) or press the shutter release To cancel the self-timer at any time, press the four-way controller ( / button halfway. The table below will help you choose the appropriate self-timer mode: Self-timer mode 2 sec. Self-timer Description The image is captured about 2 seconds after the shutter is pressed. This mode is useful for preventing camera shake. The image is captured about 10 seconds after the shutter is pressed. This mode is suitable for the shots in which the photographer has to be included. The first image is captured about 10 seconds after the shutter release button is pressed, and then the second image is captured 2 seconds later. This mode is convenient when capturing group images in succession. Flash does not fire in this mode. · After one shot is taken, the self-timer mode is turned off. · If you wish to take another image using the self-timer, repeat these steps. EN-34 Adjusting the Exposure (EV Compensation) You can manually adjust the exposure determined by the digital camera. Use this mode when the proper exposure cannot be obtained, for example, when the contrast (difference between bright and dark areas) between the subject and the background is extremely high. The EV compensation value can be set in the range from -2. 0EV to +2. 0EV. Press the power switch to turn on the power. Press the four-way controller ( / ) and use to set the range of EV compensation value from -2. 0EV to +2. 0EV. Press the button to confirm the setting. Select : EV ±0. 0 0. 0 OK : EN-35 Setting White Balance This feature lets you make adjustments to compensate for different lighting types according to your shooting conditions. Press the power switch to turn on the power. Use the four-way controller ( ) to select [W. [. . . ] EN-68 CONNECTING TO A PICTBRIDGE-COMPATIBLE PRINTER Even if you do not have a computer, you can connect the camera directly to a printer that supports PictBridge to perform image selection and printing using the camera screen and controls. DPOF support also lets you specify which images you want to print and how many copies of each should be printed. Rotate the mode dial to and turn your camera on by pressing the power switch. Press the four-way controller ( ) to select the [Set-up2] menu, then use the four-way controller ( ) to select [USB Mode]. [. . . ]