User manual SANYO VPC-T850

[. . . ] FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] Select the image that you want to edit with the / buttons. Select [Fix Red Eyes] with the / buttons, and press the button. Select [Execute] with the / buttons, and press the button. View the changes on the corrected image. To save your corrected image, select [Confirm] with the / buttons, and press the button. When this process ends, this replaces the original image with the corrected image. EN-24 Attaching Voice Memos A maximum of 30 seconds of audio can be recorded as a memo for captured still images. The voice memo can be recorded only once. Select the image to which you want to attach the voice memo with the / buttons. Select [Voice Memo] with the / buttons, and press the button. Select [On] with the / buttons, and press the button. [VOICE RECORDING] is displayed on the screen and recording starts. To stop recording a voice memo as it is being recorded, press the shutter button again. [VOICE RECORD END] will be displayed and the recording will end. An [ ] icon is displayed with images that have been recorded with a voice memo. Playing back voice memo A press of the shutter button displays [VOICE PLAYBACK] and plays back the voice memo. x aShutter:Play Shutter:Play E 100- 0001 Voice memo is only available for still images. EN-25 Protecting Images Set the data to read-only to prevent images from being erased by mistake. Select the image that you want to protect with the / buttons. Select [Protect] with the / buttons, and press the button. Select [Single] or [All] with the / buttons, and press button. Select [Set] with the / buttons, and press the button. Protection is applied to the image and the camera returns to the playback mode. The protect icon [ ] is displayed with protected images. When [All] has been selected, [ ] is displayed with all the images. Canceling the Protection To cancel protection for only one image, display the image on which you want to remove the image protection. Select [Protect] with the / buttons from the playback menu, and press the button. [. . . ] Select [PictBridge] with the / buttons, and press the button. Printing images When the camera is properly connected to a PictBridge compliant printer, the PictBridge menu is displayed on the monitor. Select the item you want to configure with the / buttons, and press the button. [Images]:Select whether you want to print specific image or all images. [. . . ]