User manual SAUNIER DUVAL EXACONTROL 1

[. . . ] As part of its policy for ongoing improvements of its products, Saunier Duval reserves the right to modify these specifications without prior notice. Saunier Duval cannot foresee all the possible circumstances that could pose a potential risk. These units have been designed and manufactured for the purposes of acclimatisation by means of air conditioning; the use thereof for other domestic or industrial purposes shall be the exclusive responsibility of the persons projecting, installing or using them in that way. Prior to the performing any work on the unit, its installation, commissioning, use or maintenance, the personnel in charge of these operations must be familiar with all the instructions and recommendations contained in the unit's installation manual. [. . . ] Saunier Duval thanks you for purchasing this unit. This product contains, amongst others, the following characteristics: Low noise emission from both the indoor and outdoor units. Use to switch the indoor and outdoor unit ON/OFF. If it is locked, we cannot use any mode function or On/Off in the unit until it is unlocked. When batteries are removed from the remote control, they should be deposited in recycling bins. The clock is only displayed if timer AUTO-ON/OFF settings are selected. 3 5 2 Fan speed indicator Displays the selected fan speed in the AUTO mode and in the three fan speed levels "I" (LOW), "II" (MED), and "III" (HIGH). as long as the modes AUTO or DRY are selected , AUTO is displayed. 3 Temperature indicator Displays the temperature setting (16°C ­ 32°C), if the fan mode is selected, the temperature indicator is displayed, if the AUTO or DRY mode is selected, the temperature indicator is only showed 25°C, it can not be adjusted. 4 LOCK indicator This indicator is displayed as long as the LOCK function is selected. After LOCK function is cancelled by pressing HOLD button again, this indicator is cleared from the display. Press TURBO again to release the Turbo mode operation. The air rate cannot be changed during Turbo mode operation. The COOL, DRY, HEAT, AUTO modes can be set during the nighttime hours to reduce the operation sound when sleeping, etc. In order to activate: With the unit connected Press the SLEEP button to reduce the air flow sound from the indoor unit. Press the SLEEP button once more to release this mode. The SLEEP mode should only be used at night. If it is used uring the day, the cooling/heating capacity will be reduced since the room temperature is too high (COOL mode). The unit is operational for a maximum of 24 hours in SLEEP mode. In COOL mode The ambient temperature gradually increases 2ºC in relation to the configured one to ensure that the temperature does not drop excessively during sleeping hours. In HEAT mode The ambient temperature gradually decreases 5ºC in relation to the configured one to ensure that the temperature does not rise excessively during sleeping hours. - During the first operating hour of the SLEEP function, the ambient temperature will drop 2ºC below the configured temperature. [. . . ] If the unit is not being used for a long period of time, remove the batteries. Two alkaline dry batteries (R03/LR03 x 2) are required for the remote control. Slide open the battery cover on the rear of the remote control according to the arrow direction. Insert two batteries and ensure the + and ­ contacts are in the correct positions. [. . . ]