User manual SAUNIER DUVAL SDH 12-025NW

[. . . ] 6- EXAMPLE FOR SETTING THE TIMER TIMER ON Use this feature if you want to start the air conditioner operation automatically at a fixed time, for example, before you come home again. 4- FONCTIONNEMENT AIR SEC START Ensure the unit is plugged and electric power is available. Carefully read the following information in order to properly handle the air conditioner. Several types of safety warnings and advice are listed below: These units should be installed and used in accordance with the Regulations and Standards for refrigerator, electrical and mechanical equipment prevailing in relation to the location of such installations. [. . . ] The remote control will send this information to the indoor unit every 3 minutes, so the temperature at the location of the remote control can be held constant. To deactivate the FOLLOW ME function, press the FOLLOW ME/AUTOCLEAN button for less than 2 seconds again. AUTOCLEAN: Press the button for more than 2 seconds to activate the AUTOCLEAN mode. In the AUTOCLEAN mode, the unit will will clean and dry the evaporator automatically and keep it fresh for the next operation. nOTE The FOLLOW ME function is not availabel in DRY and FAN mode. If the operation mode is changed or the unit is switched off, the FOLLOW ME function is cancelled, too. When the unit is switched OFF the indicator is cleared from the display. The clock is only displayed if no timer AUTO-ON/OFF settings are selected. Fan speed indicator Displays the selected fan speed in the AUTO mode and in " (MED), and the three fan speed levels " " (LOW), " " " (HIGH). After LOCK function is cancelled by pressing LOCK button again, this indicator is cleared from the display. sLEEP indicator This indicator is displayed as long as the SLEEP function is selected. After SLEEP function is cancelled by pressing TURBO/SLEEP button for more than 2 seconds again, this indicator is cleared from the display. fOLLOW ME indicator This indicator is displayed as long as the FOLLOW ME function is activated. After the FOLLOW ME function is cancelled by pressing the FOLLOW ME/AUTO CLEAN button for less than 2 seconds, this indicator is cleared from the display. NOTE The above illustration which displays all indicators at the same time is shown for informational purposes only. Setting the clock Before starting the air conditioner operation, set the clock to the current time at the remote control according to the following instructions. Then, use the bottons TEMP/TIME Increase Decrease Each time one of these buttons is pressed and released again after a moment, the time indicator increases or decreases by one minute, depending which button is pressed. the time indicator changes as fast as the button is repeatedly pressed. As long as one of these buttons is pressed and kept down pressed, the time indicator increases or decreases in steps of 10 minutes, depending which button is pressed. CLOCK button After the time indicator reached the desired time, press the CLOCK button or release button or and wait for 5 seconds. The time indicator stops flashing and the clock starts to operate. To change the current time, follow the above instructions in section "Initial setting of the clock" and "CLOCK button". [. . . ] Before turning the unit back on, check the following: that the air filters are alled, that the air inlet and outlet are not blocked up, that the remote control is fitted with batteries and that the differential switch is connected. occasionally check the base of the outdoor unit. If the base is damaged or deteriorated, the unit could fall down and cause physical or material damage. we advise you to contact a reliable air conditioner specialist or the Saunier Duval Official Technical Services to contract a preventative maintenance service. [. . . ]