User manual SAUTER SHC626WF1

[. . . ] In addition, exhaust air should not be discharged into a wall cavity, unless the cavity is designed for that purpose. The room must be well aerated in case a hood and some other heat equipment fed with an energy other than electricity (gas, oil, coal heaters, etc) operate at the same time. In fact the intake hood, disposing of air, could create a vacuum in the room. This prevents the gas exhausted by the heat source from being intaken again. [. . . ] Do not use the hob without the cassette filters. Any room where a cooker hood is used at the same time as appliances using gas or any other fuel must be properly ventilated. USE Avoid using materials which could cause spurts of flame (flambées) near the appliance. When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous in this respect. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. The appliance is supplied in the filtering version. You must remove the charcoal filter for the ducting installation. DESCRIPTION The unit can be found in filtering hoods or in exhaust hoods. 1) the air and steam taken up by the unit are purified with charcoal filters and returned to the environment through the aeration grids on the side of the flue. WARNING: When using filtering hoods, both charcoal filters and an air deflector must be used. For filtering hoods, the air exhaust grids are positioned in the upper part (Fig. For exhaust hoods, turn the upper flue over so that the air exhaust grid is in the lower section (Fig. Exhaust hoods: Connect the hood flange to the exhaust hole in the wall/ceiling using a flexible pipe. Insert the extension flues setting them on the hood; extend the upper flue to the ceiling and secure with the 2 screws (G) - Fig. Filtering hood: Secure the deflector to the upper flue using the 4 special screws (provided) – Fig. 10; hook up the flexible pipe (diameter: 125) to the deflector. Install the reduction (provided) on the hood air outlet point (Fig. Take the 2 assembled extension flues and set them on the hood; extend the upper flue to the ceiling and secure with the 2 screws (G) - Fig. Extend the lower flue taping it in place and then connect the flexible pipe to the hood reduction. Extend the lower flue downward setting it against the hood. Install the charcoal filter by pressing the 2 tabs on the filter down into the special housing (Fig. [. . . ] Replacing the charcoal filter: If the unit is a filtering hood, the charcoal filter must be replaced: to remove them press inward on the clamp (Fig. 12) and rotate the filter downward until the 2 tabs can be removed from the housing. The charcoal filter must be replaced according to use: on average once every 6 months. Lighting: To replace the incandescence bulbs, remove the fixture: apply a slight pressure on the 2 stops and at the same time push the fixture downwards (Fig. [. . . ]