User manual SCHOLTES B 20 L 2 VTC F

[. . . ] Accordingly, to regulate the power of the hob, first select the zone with key (2), then adjust the relative power level using the "+" and "-" keys (4); this done, select the timer function with key (6) and proceed to set the duration, likewise using the "+" or "-" key (4). Once the device has been activated, switch on the cooking area (within 10 seconds) as follows: Press one of the keys 1 - Premere uno dei tasti (2) per 1 ­ Appuyer sur une des touches (2) to select the cookselezionare la zona di cottura (2) pour sélectionner la zone de ing area required. Press and hold down these keys to increase or decrease the setting. Switching off the cooking area The relevant cooking deve essere attivata ed il area must already be punto decimale activated with relative corrsopondente (12) deve decimal point (12) illuessere acceso; minated. [. . . ] The function uses maximum power to preheat the cooking area to bring it to the required operating temperature. After a time interval, the power level automatically returns to the original setting. Select the required cooking area by means of the key (2). Select power level 9 by means of key "+" (4), then press the "+" key (4) again to activate preheating. To preheat the unit with spontaneous movement towards the required power level (e. "6"), set the power to 6 by means of the "-" key (4). After the system has set to automatic preheating mode, the display panel will alternate the set power level ("6") and the automatic preheating function (indicated by the letter "A"). To deactivate the preheating function (indicated by the letter "A" on the display), press the "-" key (4) at least 10 seconds since the function has been activated. This function too simplifies operation by not requiring human supervision during the cooking cycle. Once the set time on the timer has elapsed, the cooking area is automatically switched off. The cooking area must already be activated with relative decimal point (12) illuminated. Press the timer key (6); the timer display shows "00" and the indicator (10) relative to the zone being programmed lights up. Select the cooking time (between 0 to 99 minutes) by means of the "+" and "-" keys (4). the timer will start up automatically in a few seconds. Press and hold down the "+" or "-" key (4) to scroll the time setting. Press the "+" and "-" keys (4) at the same time to shut down the relative cooking area immediately. When the timer function is not programmed, the timer display can be used simply to count down minutes (i. When the displayed time elapses, the cooking area is not deactivated). When the unit is off: Use the "+" and "-" minuteur (6) keys (4) to set the re3 ­ Régler le temps quired time to be voulu avec les touches counted back. When the unit is on and a cooking area is activated: Si le dispositif est allumé et une zone de cuisson est active : When the set time has elapsed, an acoustic signal is emitted for two minutes. Switching on two zones Press key (2/2) to switch on the central zone and the circular crown. Switching on three zones Press key (2/3) to switch on the central zone, the circular crown and the external half-crown. [. . . ] If connecting directly to the mains power supply, fit a multi-pole switch of a suitable size for the rated capacity with a clearance distance which completely disconnects the power line under overvoltage category III conditions, consistently with the rules of installation (the yellow/green earth wir must not be interrupted). The plug or omnipolar switch must be easily reached on the installed equipment. The manufacturers decline any responsibility in the event of non-compliance with what is described above and the accident prevention norms not being respected and followed. To avoid all risk, if the power cable becomes damaged, it must only be replaced by the manufacturer, by an authorised service centre, or by a qualified electrician. [. . . ]