User manual SCHOLTES CI 96I A

[. . . ] Setting the clock Setting the timer Using the oven Manual cooking modes Automatic cooking modes Programming cooking Practical cooking advice Oven cooking advice table Switching on the hob Switching on the cooking zones Booster function Switching off the cooking zones Programming the cooking duration Timer Control panel lock Switching off the hob Demo mode Practical advice on using the appliance Safety devices Technical description of the models Practical cooking advice Switching the appliance off Cleaning the appliance Replacing the oven light bulb Cleaning the glass ceramic hob Automatic cleaning using the PYROLYTIC cycle Please keep this instruction booklet in a safe place for future reference. Make sure the booklet remains with the appliance if it is sold, given away or moved. The appliance must be installed by a qualified professional in accordance with the instructions provided. Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. [. . . ] Press the button repeatedly until the duration you wish to change is shown. To switch off a cooking zone, select it using the corresponding selector button and: To cancel a programme, follow the above instructions. The timer can be used to set a duration up to 99 minutes. When the hob is switched on again it will be set to the "demo" mode. To exit this mode, follow the procedure described above. the display will show the text DE and OF and the hob will be switched off. When it is next switched on, the hob will function normally. Practical advice on using the appliance When the time has elapsed, a buzzer will sound (for one minute). Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. When the hob is switched on, it is possible to lock the oven controls in order to avoid accidental changes being made to the settings (by children, during cleaning, etc. Press the button to lock the control panel: the indicator light above the button will switch on. To stop cooking), you must switch off this function. Press the button for a few moments, the indicator light will switch off and the lock function will be removed. Use pans with a thick, flat base in order to fully utilise the cooking zone. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. Always use pans with a diameter which is large enough to cover the hotplate fully, in order to use all the available heat. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the "demo" mode the hob must be switched on, with all the hotplates switched off. Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware. Avoid using the same cookware which has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, causing it not to adhere correctly. [. . . ] Do not place tea towels or pot holders over the oven handle. If the oven is too hot, the pyrolytic cycle may not start. The programme may only be started once the oven door has been closed. to activate the PYROLITIC CYCLE cleaning procedure , press and hold the button for approximately 4 seconds. [. . . ]