User manual SCHOLTES LTE 14-H208 A

[. . . ] Starting the dishwasher Measuring out the detergent Wash options Measuring out the rinse aid Measuring out the refined salt Shutting off the water and electricity supplies Cleaning the dishwasher Preventing unpleasant odours Cleaning the sprayer arms Cleaning the water inlet filter Cleaning the filters Leaving the machine unused for extended periods General safety Disposal Saving energy and respecting the environment Keep this instruction manual in a safe place for future reference. If the appliance is sold, given away or moved, please ensure the manual is kept with the machine, so that the new owner may benefit from the advice contained within it. Please read this instruction manual carefully: it contains important information regarding the safe installation, use and maintenance of the appliance. If the appliance must be moved at any time, keep it in an upright position; if absolutely necessary, it may be tilted onto its back. [. . . ] To cancel it, press the button repeatedly until the selected delayed start indicator light switches off. The wash cycle will start automatically as soon as the door is shut. If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or once the electricity supply is restored. The number and type of wash cycles and options may vary depending on the dishwasher model. Wash Cycles which include drying Yes Environmentally-friendly wash cycle with low energy consumption levels, suitable for pans and dishes. Pre-wash for dishes while awaiting completion of the load with the dishes from the next meal. Economic and fast wash to be used for lightly soiled dishes. Pour in the rinse aid, making sure it does not overflow from the dispenser. If this happens, clean the F spill immediately with a dry cloth. 5* 34 - 50 61 - 90 6, 1 - 9 2/3 weeks For values between 0°f and 10°f, we do not recommend the use of salt. * this setting may cause a slight increase in the the cycles. In order to achieve the best possible results using a wash cycle, make sure that the dispenser is never empty. refined salt removes limescale from the water , thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: · When the green float* cannot be seen by simply looking at the cap of the salt dispenser. ⷠWhen the LOW SALT* indicator light on the control panel is illuminated; 1. The first time you do this: fill the water tank right up to its edge. Position the funnel* (see figure) and fill the salt container right up to its edge (this should hold approximately 1 kg); it is not unusual for a little water to leak out. Remove the funnel* and wipe any salt residue away from the opening; rinse the cap under running water and then screw it on, the head facing downwards so as to let the water flow out of the four cracks which are arranged in a star shape on the lower part of the cap. (Salt cap with green float*) It is advisable to perform this procedure every time you add salt to the container. Make sure the cap is screwed on tightly, so that no detergent can get into the container during the wash cycle (this could damage the water softener beyond repair). When necessary, measure out the salt before a wash cycle so that any saline solution which has leaked out of the salt dispenser is removed. [. . . ] Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. Whenever the appliance fails to work, check for a solution from the following list before calling for Assistance. problem: The dishwasher does not start or cannot be controlled Switch off the appliance by pressing the ON/OFF button, switch it back on after approximately one minute and reset the program. [. . . ]