User manual SCHOLTES LVX 9-44

[. . . ] NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: - 73/23/EEC (Low Voltage) and subsequent modifications; - 89/336/EEC (ElectromagneticCompatibility)and subsequent modifications. After removing the packing, check to make sure that the appliance is not damaged. The dishwasher must only be used by adults for the washing of household dishes and cooking utensils. [. . . ] These phases are: There's been a power failure?The wash cycle stops and then restarts when the electricity comes back on or when you shut the door. The end of the wash cycle is indicated by two short beeps and the flashing of the drying phase indicator light. Turn the knob anti-clockwise to Reset in order to reset all the settings. Warning: Press button "A" to turn the appliance off, unplug the appliance from the electricity socket to cut off the power supply; the power supply cable should consequently be easily accessible. Wait a few minutes before unloading the dishes: they are very hot!If you wait a little while, they dry better thanks to the steam. Make sure the wash cycle has ended before removing the dishes!Warning: If opening the door soon after the end of the programme, or during it, stand away from the Dishwasher, to avoid possible injury from hot steam. You can modify the wash cycle in progress, if it has only just started. Turn the knob anti-clockwise until it reaches the Reset position and, after a few seconds, you will hear 4 beeps and indicator light "G" will turn off. This is to inform you that all the settings have been cancelled. You are now free to re-set the correct wash cycle. You can interrupt the wash cycle by pressing the ON-OFF button, insert the dish you had forgotten and press the ONOFF button again. The cycle will start up from where you interrupted it. If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. Very dirty dishes and pans (not to be used for delicate items) Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. Economic and fast cycle to be used for slightly dirty dishes. Without drying Preliminary wash cycle for dishes and pans awaiting completion of the load with the dishes from the next meal. Special cycle to be used for more delicate items which are sensitive to high temperatures. Pre-wash with hot water at 40°C Wash at 63°C 2 Cold rinse Hot rinse at 67°C Drying Wash at 60° Cold rinse Hot rinse at 70°C Drying Pre-wash with cold water Wash at 48°C Cold rinse Hot rinse at 60°C Drying Short wash at 48°C. Short cold wash to prevent food from drying onto the dishes. [. . . ] If the water hoses are new or have been out of use for an extended period of time, let the water run to make sure it is clear and free of impurities before making the connection. If this precaution is not taken, the water inlet could get blocked, causing damage to your dishwasher. - It is strongly recommended to use a new hose to connect the dishwasher to the water supply line, and the old hoseset should not be reused. Asking to specilized shop or an authorized service technician (see Service). [. . . ]