User manual SCHOLTES PP 63 G AT

[. . . ] However, these rooms must not be shared living rooms, bedrooms or rooms presenting a fire hazard. Liquid petroleum gas sinks to the floor as it is heavier than air. Therefore, rooms containing LPG cylinders must also be equipped with vents in order to allow gas to escape in the event of a leak. As a result LPG cylinders, whether partially or completely full, must not be installed or stored in rooms or storage areas which are below ground level (cellars, etc. [. . . ] Before carrying out the connection, make sure the cooker is compatible with the gas supply you wish to use. If this is not the case, follow the instructions indicated in the paragraph "Adapting to different types of gas". When using liquid gas from a cylinder, install a pressure regulator which complies with current national regulations and subsequent amendments. Make sure that the gas supply pressure is consistent with the values indicated in Table 1, "Burner and nozzle specifications". This will ensure the safe operation and durability of your appliance while maintaining efficient energy consumption. connection with a rigid pipe (copper or steel) !Connection to the gas system must be carried out in such a way as not to place any strain of any kind on the appliance. There is an adjustable L-shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal supplied with the appliance). These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not crushed. Each burner can be adjusted to one of the following settings using the corresponding control knob: 0 Off Maximum Minimum To light one of the burners, hold a lit match or lighter near the burner and, at the same time, press down and turn the corresponding knob anti-clockwise until it reaches the maximum setting. For models fitted with a safety device, the knob should be held down for approximately 2-3 seconds, until the automatic device keeping the flame alight has heated up. When using models with an ignition button, light the desired burner by pressing down the corresponding knob as far as possible and turning it anti-clockwise towards the maximum setting, keeping it pressed down until ignition has been achieved. In this case, to activate it, simply start by turning the knob so that it is aligned with the symbol, then press it all the way in and hold it in this position for approximately 6 seconds, until the automatic device keeping the flame alight has heated up. If the burner flame is accidentally extinguished, shut off the control knob and wait for at least one minute before attempting to light the burner again. To switch off the burner, turn the knob in a clockwise direction until it stops (position marked by the "0" symbol). The "independent double flame" burner: This gas burner consists of two concentric flame rings which can be used together or independently of each other. Using both simultaneously at maximum power makes it possible to reach a higher overall power level, thus reducing cooking time with respect to the time required by traditional burners. The double flame ring also distributes heat more evenly across the base of the pan, especially when both burners are set to the minimum power level. To ensure that the double-flame burner is used to its full potential, never set the inside ring to minimum and the outside ring to maximum at the same time. Cookware of all sizes may be used; when cooking with small recipients use only the inner burner. [. . . ] Disconnect your appliance from the electricity supply before carrying out any work on it. Do not use abrasive or corrosive detergents such as stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. Never use steam cleaners or pressure cleaners on the appliance. It is usually sufficient simply to wash the hob using a damp sponge and dry it with absorbent kitchen towel. [. . . ]