User manual SCHOLTES SCHG 751 GH

[. . . ] SCHG 640 GH SCHG 751 GH Français Mode d’emploi TABLE DE CUISSON Sommaire Mode d’emploi, 1 Avertissements, 3 Assistance, 6 Description de l’appareil, 8 Installation, 24 Mise en marche et utilisation, 29 Précautions et conseils, 29 Nettoyage et entretien, 30 Anomalies et remèdes, 31 Italiano Español Istruzioni per l’uso PIANO Sommario Istruzioni per l’uso, 1 Avvertenze, 2 Assistenza, 5 Descrizione dell’apparecchio, 7 Installazione, 10 Avvio e utilizzo, 14 Precauzioni e consigli, 15 Manutenzione e cura, 15 Anomalie e rimedi, 16 Manual de instrucciones ENCIMERA Sumario Manual de instrucciones, 1 Advertencias, 3 Asistencia, 6 Descripción del aparato, 8 Instalación, 32 Puesta en funcionamiento y uso, 36 Precauciones y consejos, 36 Mantenimiento y cuidados, 37 Anomalías y soluciones, 38 English Portuges Operating Instructions HOB Contents Operating Instructions, 1 Warnings, 2 Assistance, 5 Description of the appliance, 7 Installation, 17 Start-up and use, 21 Precautions and tips, 22 Maintenance and care, 22 Troubleshooting, 23 Instruções para a utilização PLANO Índice Instruções para a utilização, 1 Advertências, 4 Assistência, 6 Descrição do aparelho, 9 Instalação, 39 Início e utilização, 43 Precauções e conselhos, 43 Manutenção e cuidados, 44 Anomalias e soluções, 45 Avvertenze ATTENZIONE: Questo apparecchio e le sue parti accessibili diventano molto caldi durante l’uso. ATTENZIONE: In caso di danneggiamento del piano in vetro: - spegnere immediatamente tutti i bruciatori ed eventuali elementi riscaldanti elettrici e scollegare l’apparecchio dalla rete elettrica - non toccare la superficie dell’apparecchio Warnings WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised. [. . . ] In the case of the Mini WOK*, use a spanner with a 7 mm opening to unscrew the nozzle (see figure). The hob can only be installed above built-in ovens with a cooling ventilation system. Electrical connection Hobs equipped with a three-pole power supply cable are designed to operate with alternating current at the voltage and frequency indicated on the data plate (this is located on the lower part of the appliance). The earth wire in the cable has a green and yellow cover. If the appliance is to be installed above a built-in electric oven, the electrical connection of the hob and the oven must be carried out separately, both for electrical safety purposes and to make extracting the oven easier. Connecting the supply cable to the mains Install a standardised plug corresponding to the load indicated on the data plate. The appliance must be directly connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the appliance and the mains. The circuit-breaker must be suitable for the charge indicated and must comply with current electrical regulations (the earthing wire must not be interrupted by the circuit-breaker). The supply cable must not come into contact with surfaces with temperatures higher than 50°C. The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: • The appliance is earthed and the plug is compliant with the law. € The socket can withstand the maximum power of the appliance, which is indicated on the data plate. € The voltage is in the range between the values indicated on the data plate. € The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it. Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. Once this procedure is finished, replace the old rating sticker with one indicating the new type of gas used. Stickers are available from any of our Service Centres. Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet pipe (in order to comply with current national regulations). The position of the corresponding gas burner or electric hotplate* is shown on every knob. Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: ● Off Maximum Minimum To turn on one of the burners, place a lighted match or lighter near the burner, press the knob all the way in and turn it anti-clockwise to the “High” setting. Since the burner is fitted with a safety device, the knob should be pressed for approximately 2-3 seconds to allow the automatic device keeping the flame alight to heat up. [. . . ] If this happens, the tap must be replaced. This procedure must be performed by a qualified technician authorised by the manufacturer. Disposal • When disposing of packaging material: observe local legislation so that the packaging may be reused. € The European Directive 2012/19/EC on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. [. . . ]