User manual SCHOLTES SOTTO TAVOLO RTS 1632

[. . . ] Français Mode d’emploi SC09ULAAI SC09ULABI RTS 1632 REFRIGERATEUR Sommaire Mode d’emploi, 1 Assistance, 3 Description de l’appareil, 7 Installation, 16 Mise en marche et utilisation, 16 Entretien et soin, 17 Précautions et conseils, 17 Anomalies et remèdes, 18 Italiano Español Istruzioni per l’uso FRIGORIFERO Sommario Istruzioni per l’uso, 1 Assistenza, 3 Descrizione dell’apparecchio, 6 Installazione, 10 Avvio e utilizzo, 10 Manutenzione e cura, 11 Precauzioni e consigli, 11 Anomalie e rimedi, 12 Manual de instrucciones FRIGORÍFICO Sumario Manual de instrucciones, 1 Asistencia, 4 Descripción del aparato, 7 Instalación, 19 Puesta en funcionamiento y uso, 19 Mantenimiento y cuidados, 20 Precauciones y consejos, 20 Anomalías y soluciones, 21 English   Operating Instructions FRIDGE Contents Operating Instructions, 1 Assistance, 3 Description of the appliance, 6 Installation, 13 Start-up and use, 13 Maintenance and care, 13 Precautions and tips, 14 Troubleshooting, 15      Assistenza Attiva 7 giorni su 7 Assistance Before calling for Assistance: • Check if the malfunction can be solved on your own (see Troubleshooting). € If after all the checks, the appliance still does not operate or the problem persists, call the nearest Service Centre Communicating: • type of malfunction • appliance model (Mod. ) • serial number (S/N) This information can be found on the data plate located on the bottom left side of the refrigerator compartment. Never call on unauthorized technicians and always refuse spare parts which are not originals. [. . . ] TEMPERATURE Indicator light: to identify the coldest area in the refrigerator. Check that OK appears clearly on the indicator light (see diagram). If the word “OK” does not appear it means that the temperature is too high: adjust the REFRIGERATOR OPERATION knob to a higher (colder) position and wait approximately 10 hours until the temperature has stabilised. Check the indicator light again: if necessary, readjust it following the initial process. If large quantities of food have been added or if the refrigerator door has been opened frequently, it is normal for the indicator not to show OK. Wait at least 10 hours before adjusting the REFRIGERATOR OPERATION knob to a higher setting. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (15W or 25W). Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply. It is not sufficient to set the temperature adjustment knobs on (appliance off) to eliminate all electrical contact. The appliance was designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. € The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. € If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. This appliance complies with the following Community Directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; -89/336/EEC of 03. Do not speed up the defrosting process by using any devices or tools other than the scraper provided, you may damage the refrigeration circuit. Defrosting the refrigerator compartment The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. [. . . ] • The door is not closed properly or is continuously opened. € The outside ambient temperature is very high. • The thickness of the frost exceeds 2-3 mm (see Maintenance). € The appliance has not been installed on a level surface (see Installation). [. . . ]