User manual SCHOLTES TI 6533

[. . . ] Incorrect installation may cause harm to people and animals or may damage property. If the appliance is to be installed above an oven, the oven must be equipped with a forced ventilation cooling system. Avoid installing the hob above a dishwasher: if this cannot be avoided, place a waterproof separation device between the two appliances. Depending on the hob you want to install, the cabinet must have the following dimensions (see figure): Keep all packaging material out of the reach of To allow adequate ventilation and to avoid overheating of the surrounding surfaces the hob should be positioned as follows: At a minimum distance of 40 mm from the back panel or any other vertical surfaces. [. . . ] The lights corresponding to the other hotplates programmed will be switched on. to display the time remaining for the other programmed hotplates , press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration buttons to set the new duration. The booster function for some of the cooking zones may be used to shorten heating-up times. Light directly above the button will illuminate. This function boosts the power to 2000 W or 3000 W, depending on the size of the relevant cooking zone. The booster stops automatically after 4 minutes. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). To cancel a programme, follow the above instructions. Safety switch The appliance has a safety switch which automatically switches the cooking zones off after they have been in operation for a certain amount of time at a particular power level. When the safety switch has been triggered, the display shows 0. Or example: the right rear hotplate is set to 5 and will switch off after 5 hours of continuous operation, while the front left hotplate is set to 2 and will switch off after 8 hours. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. If the indicator light is flashing, it may indicate: An incompatible pan A pan whose diameter is too small The pan has been removed from the hotplate. Residual heat indicators Each cooking zone is equipped with a residual heat indicator. This indicator signals which cooking zones are still at a high temperature. If the power display shows , the cooking zone is still hot. It is possible, for example, to keep a dish warm or melt butter or chocolate. Overheating protection If the electronic elements overheat, the hob switches off automatically and followed by a flashing number. When the temperature has reached a suitable level, this message disappears and the hob may be used again. [. . . ] The appliance must be used by adults only for the preparation of food, in accordance with the instructions provided in this booklet. do not use the hob as a worktop or chopping board. The glass ceramic hob is resistant to mechanical shocks, but it may crack (or even break) if hit with a sharp object such as a tool. If this happens, disconnect the appliance from the electricity mains immediately and contact a Service Centre. [. . . ]