User manual SCHOLTES TI 7624

[. . . ] Incorrect installation may cause harm to people and animals or may damage property. If the appliance is to be installed above an oven, the oven must be equipped with a forced ventilation cooling system. Avoid installing the hob above a dishwasher: if this cannot be avoided, place a waterproof separation device between the two appliances. Depending on the hob you want to install, the cabinet must have the following dimensions (see figure): Keep all packaging material out of the reach of To allow adequate ventilation and to avoid overheating of the surrounding surfaces the hob should be positioned as follows: At a minimum distance of 40 mm from the back panel. [. . . ] The fan functions at maximum power when the large induction element is at maximum power or when the booster function is on; in all other cases, it works at average power depending on the temperature detected. Urthermore, the fan may continue to work even after switching the hob off, if the temperature detected is high. The types of noise listed above are due to induction technology and are not necessarily operational faults. To switch off a cooking zone, select it using the corresponding selector button and: Press power level selector button 0: this immediately returns the power setting to 0 and the cooking zone switches off. The booster function for some of the cooking zones may be used to shorten heating-up times. Light directly above the button will illuminate. This function boosts the power to 2000 W or 3000 W, depending on the size of the relevant cooking zone. The booster stops automatically after 4 minutes. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. If the booster for the rear left-hand hotplate has been activated, the power level of the front left-hand hotplate will be reduced). All the cooking zones may be programmed simultaneously, for a duration between 1 and 99 minutes. Press the programming button until the timer indicator light is illuminated. When the hob is switched on again it will be set to the demo mode. To exit this mode, follow the procedure described above. When it is next switched on, the hob will function normally. Practical advice on using the appliance Use cookware made from materials which are compatible with the induction principle (ferromagnetic material). We especially recommend pans made from: cast iron, coated steel or special stainless steel adapted for induction. Overheating protection If the electronic elements overheat, the hob switches off automatically and followed by a flashing number. When the temperature has reached a suitable level, this message disappears and the hob may be used again. Safety switch The appliance has a safety switch which automatically switches the cooking zones off after they have been in operation for a certain amount of time at a particular power level. When the safety switch has been triggered, the display shows 0. Or example: the right rear hotplate is set to 5 and will switch off after 5 hours of continuous operation, while the front left hotplate is set to 2 and will switch off after 8 hours. [. . . ] To avoid any interference between your induction hob and a pacemaker, the latter must be designed to comply with relevant regulations. In this respect, we can only guarantee our own product conformity. Please consult the pacemaker manufacturer or your doctor concerning its conformity or any possible incompatibility. Do not let children play with the appliance. [. . . ]