User manual SCHOLTES TRC 630 C

[. . . ] à au moins 40 mm de distance du mur arrière; de manière à ce quil reste au moins 20 mm de distance entre la découpe dencastrement et le meuble en dessous. Switching on the hob Switching on the cooking zones Switching off the cooking zones Power function Heating elements Programming the cooking duration Timer Control panel lock Switching off the hob Demo mode Practical advice on using the appliance Safety devices Practical cooking advice Please keep these operating instructions for future reference. Pass them on to any new owners of the appliance. Before operating your new appliance please read The appliance must be installed by a qualified professional in accordance with the instructions provided. [. . . ] The display, the power level indicator, will alternately show the letter P and the power level set previously until the desired power level has been reached. Once this level has been reached, the display will revert to showing the set power level. To deactivate this function, press and hold for at least 2 seconds - the selector button corresponding to the cooking zone on which the using the buttons function has been activated; alternatively, select a different power level A buzzer sounds for approximately 1 minute and the cooking zone switches off when the set programme has finished. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will flash. The lights corresponding to the other hotplates programmed will be switched on. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration buttons to set the new duration. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the demo mode the hob must be switched on, with all the hotplates switched off. press and hold the simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/O. To cancel a programme, follow the above instructions. At step 2, press the duration decreases progressively until it reaches 0 and switches off. The timer can be used to set a duration up to 99 minutes. Press the programming button until the timer indicator light is illuminated. When the hob is switched on again it will be set to the demo mode. To exit this mode, follow the procedure described above. When it is next switched on, the hob will function normally. When the time has elapsed, a buzzer will sound (for one minute). [. . . ] The European Directive 2002/96/EC relating to Waste Electrical and Electronic Equipment (WEEE) states that household appliances should not be disposed of using the normal solid urban waste cycle. Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. Or further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer. [. . . ]