User manual SCHOLTES TT 6234

[. . . ] Switch off the main switch and gas supply when you are not using the hob. The gas burners and pan supports remain heated for a long time after use. To avoid accidental spillage do not use cookware with uneven or deformed bottoms on the burner. Do not use steam cleaners to clean your oven. [. . . ] To obtain the best results with the cooktop, several fundamental rules should be followed while cooking or preparing food. Use cookware with a flat bottom to make certain that the pot sets properly on the cooking area. Note When there is no electricity supply, the burners can be lit with a match after turning the control knob to the flame position. To turn on one of the burners, place a lighted match or lighter near the burner, press the knob all the way in and turn it anticlockwise to the "High" setting. To ensure long life of the appliance, it is essential to carry out a thorough general clean frequently, taking into account that: · The appliance should be disconnected from the mains supply before starting cleaning operations. Avoid cleaning appliance parts when they are still warm. The enamelled or chromed or glass parts must be washed with warm water without using abrasive powders or corrosive substances which could ruin them. The steel parts, especially in areas with the screen-printed symbols, should not be cleaned with diluents or abrasive detergents; preferably use just a soft cloth moistened with warm water and liquid detergent for washing dishes (wipe the cloth over the steel in the same direction as the satinfinish). Denatured alcohol may be used to remove stubborn dirt. Stainless steel can be stained if it remains in contact with agressive detergents (containing phosphorus) or water with a high lime content. After washing the stainless steel parts they should be rinsed and dried with a soft cloth (washleather). The electric fan should have a sufficient capacity to guarantee an hourly exchange of air equal to 3-5 times the volume of the kitchen. Prolonged, intensive use of the appliance may require extra ventilation, e. An open window or a more efficient ventilation system by increasing the extraction power of the electric fan if installed. Liquid petroleum gas descends towards the floor as it is heavier than air. Apertures in the outside walls in rooms containing LPG cylinders should therefore be at floor level, in order to allow any gas from leaks to be expelled. Do not store LPG cylinders (even when empty) in basements/rooms below ground level; it is advisable to keep only the cylinder in use in the room at any one time and connected far from heat sources which could raise its temperature to above 50 °C. Make sure you take all the necessary precautions to guarantee proper installation in compliance with the applicable norms in force regarding accident-prevention for electrical connection. For the correct operation of the appliance when built into the cabinet, it is vital that the minimum distances illustrated in Fig. The hob features a type Y degree of protection against overheating in compliance with norms. All surfaces adjacent to the cabinet and the back panel should be made of materials resistant to a temperature of 65°C. Kitchen ventilation The air flow into the room where the appliance is installed must equal the quantity of air that is required for regular combustion of the gas and for ventilating the same room. [. . . ] make sure that the local supply voltage corresponds to the voltage indicated on the rating plate. Connecting the supply cable to the mains electricity supply For models supplied without a plug, fit a standard plug, suitable for the load indicated on the rating plate, onto the cable and connect to a suitable socket. To connect directly to the mains supply, a double-pole switch with a contact separation of at least 3 mm suitable for the load and complying with current standards and regulations, must be fitted between the appliance and the mains supply outlet. The yellow-green earth wire must not be interrupted by the switch. [. . . ]