User manual SCHOLTES UNA PORTA RS 3032 V L

[. . . ] € The socket can withstand the maximum power of the appliance, which is indicated on the data plate located on the bottom left side of the fridge (e. € The voltage must be in the range between the values indicated on the data plate located on the bottom left side (e. € The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it (see Assistance). [. . . ] This is useful, for example, when you place a large number of new food items inside the refrigerator and you need to counteract the slight rise in its internal temperature. This function is automatically deactivated after the required amount of time has passed. € Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). € Remember that cooked foods do not last longer than raw foods. • Do not store liquids in open containers. They will increase humidity in the refrigerator and cause condensation to form. € The top salad crispers, which are colder than the bottom one, are more suited to the preservation of delicate fruits and vegetables such as: grapes, strawberries, figs, cherries, fruits of the forest, mushrooms, asparagus, red tomatoes, artichokes etc. ; whereas the bottom crisper is ideal for storing pineapples, avocados, citrons, lemons etc. A A Pure Wind System maximises air circulation, improving the efficiency of the evaporator and helping to achieve the optimal temperature inside the refrigerator as quickly as possible each time it has been opened. The blown air (A) is cooled when it comes into contact with the cold wall, whereas the hotter air (B) is sucked up (see diagram). 34 Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: Simply using the ADJUSTMENT button until all indicator lights are switched off (appliance switched off) is not enough to eliminate all electrical contact. Do not use objects with sharp or pointed edges to defrost the appliance as these may damage the refrigeration circuit beyond repair. GB Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. € If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. It is necessary to clean the discharge hole regularly so that the water can flow out easily. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (10W or 15W). The appliance was designed and manufactured in compliance with international safety standards. [. . . ] The food inside the refrigerator is beginning to freeze. The alarm sounds and the set temperature indicator lights flash (all of them excluding the Super Cool indicator light which is turned off). The back wall of the refrigerator unit is covered in frost or droplets of water. There is water at the bottom of the refrigerator. [. . . ]