Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SCOPEX 4D-10B. We hope that this SCOPEX 4D-10B user guide will be useful to you.
Lastmanuals help download the user guide SCOPEX 4D-10B.
Detailed instructions for use are in the User's Guide.
[. . . ] Installation and wiring must be in compliance with your local building and electrical installation codes. Power cables must only be connected to a properly earthed supply. Any entrapment possibility by the moving wing between wing & walls must be secured with safety edges or IRsensors. Please remove any locks fitted to the gate in order to prevent damage to the gate. [. . . ] Left stop: Automatic closing OFF The control board complies with the latest EU guidelines. One of these guidelines specifies that the closing forces at the gate edge must not exceed 400 N (40 kg) for the last 500 mm before the door is CLOSED. Above 500 mm, the maximum force at the gate edge must not exceed 1400 N (140 kg). If this cannot be ensured, a contact strip must be mounted on the gate at a height up to 2. 5 m or on the opposite pillar (EN12453). PT3 (TRIMMING POTENTIOMETER 3): FORCE SETTING (FORCE 1 MASTER) Definition of the force with which motor 1 = master is to operate. The required force depends on weight and function of the gate. PT4 (TRIMMING POTENTIOMETER 4): FORCE SETTING (FORCE 2 SECOND) Definition of the force with which motor 2 = second is to operate. The required force depends on weight and function of the gate. Only modify settings when control bord is disconnected. Otherwise modifications will not be accepted!The control board must be disconnected from the mains for a few seconds. Note: It is not possible to combine different photocell models. The flashing light should be fitted as high as possible and in good clear view. Voltage: 24 V DC Do not use any fixed copper lines. Do not lay any 230 volt cables in parallel and do not lay any 2 cables in the same cable trunking. PUSHBUTTON / KEY-OPERATED SWITCH (OPTIONAL) The control board / drive can be activated using various inputs. This can be done using a transmitter or keyswitch (terminals 17 and 20). Transmitter = see "Teaching the transmitter" Switch input 1 = input control 1 normal operation Switch input 2 = input control 2 active for special settings (see Dip switch description) EMERGENCY STOP (OPTIONAL) A switch can be connected to stop or disable the unit. Do not lay any 230 volt cables in parallel and do not lay any 2 cables in the same cable trunking. 2 kilo ohm principle can be connected to the control board, i. The control board is supplied with an 8. [. . . ] Capacitor is not correctly connected to the brown and black cable. The controller doesn't respond when I alter the Dip-switches. The gate opener only works when I press and hold the button on the remote control. A safety facility is not working correctly (photocell, safety edge). [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SCOPEX 4D-10B
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SCOPEX 4D-10B will begin.
