User manual SCOTSMAN CSWE1

[. . . ] CSWE1 Introduction This product manual is intended for users and servicers of the CSWE1 Automatic Ice Machine. Table of Contents Specifications: . What to expect: Maintenance: . . . . . . . . . . . . . . . . . . . . . 2 3 4 5 6 7 8 9 10 11 12 13 14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cleaning the interior components. [. . . ] If needed, adjust thickness by rotating the ice thickness knob. 2 December 1995 Page 5 CSWE1 Changing the bin door and lower panels. The bin door and lower panels can be customized to match wood cabinets. The size of the door panel is: 11 1/4" high x 17" wide. The size of the lower panel is: 11 15/16" high x 17" wide. Cut panels, making sure that the wood grain matches the direction of the cabinet wood grain. It is a good idea to cover the edges of a wood panel with moisture resistant sealant. Open the bin door and remove the two screws holding the handle to the top of the door, remove the handle. Remove the three screws that hold the lower panel assembly and the two screws at the top of the lower panel. Remove the top of the lower panel assembly. 3. Break off the ribs on the door insulation. Slide the wood panel into the bin door frame. Reattach the handle with the two screws. Slide the metal panel and the spacer panels out of the lower panel assembly. 3. Slide the metal panel back into the lower panel assembly, slide the wood panel in front of the metal panel. Reattach the top of the panel with the two screws and replace the three screws that hold the lower panel assembly. December 1995 Page 6 CSWE1 What to expect: When the machine is on, and making ice the compressor, fan motor and water pump will be on. Periodically, the water pump and fan will stop and ice will be "harvested". The ice machine must have good ventilation in order to work properly. Do NOT block the air flow in front of the machine. Water flows over an inclined freezing surface, and gradually freezes into a slab. The ice size thermostat measures the temperature of the freezing surface and the setting of that thermostat determines the thickness of the slab. During the ice release cycle, the ice slab slides down onto a hot wire cutter grid and, after the grid melts thru the ice, the individual cubes fall into the ice storage bin portion of the machine. The ice machine will continue to produce ice until the bin is full. Then the ice machine will shut down until the level of ice in the bin falls below the bin thermostat well. The ice storage bin is not refrigerated, so there will be some melting. [. . . ] They cannot withstand temperatures above 145oF. Replace the interior components (water distributor, inlet hose, water pan, cutter grid, and ice retainer baffle). 4. Remove the water pan by unscrewing the two thumb screws. 9. Check the following: · Hose from water valve is in the water pan. [. . . ]