User manual SCOTSMAN FME2400RH

[. . . ] FME2400RH TO THE OWNER OR USER: The service manual you are reading is intended to provide you, and the maintenance or service technician, with the information needed to install, start up, clean, maintain and service this ice system. The FME2400RH (remote high side) is the freezer portion of a commercial ice machine. It is designed to be connected to the condensing section of a refrigeration system, specifically a supermarket R-404A system. Table of Contents FOR THE INSTALLER: Specifications FOR THE INSTALLER . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page 9 Page 10 Page 11 Page 12 Page 13 Page 14 Page 15 Page 16 Page 17 Page 18 Page 19 Page 20 Page 21 Page 22 Page 23 Page 24 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FOR THE ELECTRICIAN . [. . . ] See Removal and Replacement to replace bearing or seals. Check and tighten all bolts and screws. RESERVOIR ICE SWEEP CLEAN THE WATER LEVEL SENSOR ///////////////////////////// CAUTION: THE TIMP IS MADE OF GLASS /////////////////////////////// BREAKER COVER 3. The bearing in the breaker should also be checked at least two times per year. Check the bearing by: ·pushing the bail clamp back and removing the ice chute cover ·unscrewing the ice sweep ·unscrewing the breaker cover ·unscrewing the auger stud January 1995 Page 15 FME2400RH CLEANING In some installations the water supply to the ice maker will be so concentrated with dissolved minerals, (such as calcium carbonate) that as ice is made, the evaporator and auger become coated with the minerals, requiring a more frequent cleaning than twice per year. If in doubt about the condition of the evaporator and auger, the auger can be removed so the parts can be inspected. Note: Water filters can filter out suspended solids, but not dissolved solids. "Soft" water may not be the complete answer. Check with a water treatment specialist regarding water treatment. Switch off electrical power, and shut off the water supply. For more information on removal of these parts, see REMOVAL AND REPLACEMENT. To remove the auger, remove front and top panel. If top panel cannot be removed, or if there is less than 6" clearance over the top of the machine, the gearmotor/evaporator may be slid out for service access. Push bail clamp back and remove ice chute cover. Loosen band clamp under ice chute, and remove ice chute from evaporator. Remove 4 allen head screws holding breaker to evaporator. Allow the auger to dry, the stainless steel of the auger and evaporator must be clean and bright. Clean the auger and evaporator as required. Reverse to reassemble. DIVIDER, AUGER AND SLOTTED COLLAR ALLEN HEAD SCREWS January 1995 Page 16 FME2400RH SERVICE DIAGNOSIS: Condition - No Ice Being Produced STATUS: NOTHING OPERATES A. Check: Voltage to the unit, restore it if there is none. Check: The master switch, switch ON if off. The machine will not run if there is not enough water in the reservoir. Restore/adjust water level. STATUS: NOTHING OPERATES D. [. . . ] Note: The gears and bearings are available only as pressed together sets. D) After replacing parts as required, (if any) reassemble the gearcase. The two smaller gears and the oil should be in the lower case, the output gear will be with the cover. As you lower the cover onto the lower case, cover will have to be moved closer to the second gear after the output gear has cleared the second gear top bearing. [. . . ]