User manual SCOTSMAN HD150

[. . . ] ·Compatible only with Scotsman CME306 or CME456 brand models. ·Must allow space for utility connections at the back. Optional Kits (for HD150-1A) Include: Coin Mechanism, kit number KSLDC2 Key Mechanism, kit number KSLDK2 All kits are field installed. Top View of HD150 Dimensions Basic (with legs) Electrical WxDxH HD150S-1A 22" x 32" x 50" 115/60/1 Model Finish Ice Storage Capacity 90 lb. Max Fuse Size 15 Min Circuit Ampacity 2. 9 Stainless Steel May 2000 Page 2 HD150 Installation: General After the carton has been removed from the dispenser, the legs may be installed. Place flat portions of the carton on the floor behind the dispenser and lay the dispenser down on its back. [. . . ] Place a container in the drop zone of the dispenser. Place a quarter in the slide of the coin 19. Check operation of coin box and key lock. After everything is operating, give key to user. Control Box Layout Control Relay Coin Mech Relay Electrical Shock Hazard. Disconnect electrical power before beginning procedures. Adjustment Coin Mech Timer Agitation Timer Electrical Sequence 1. Coin switch closes, connecting power to timer. Timer closes internal contacts, connecting power to gearmotor (and door solenoid if -1B) 3. Gearmotor rotates dispense wheel until internal timer contacts (AND cam switch contacts if -1) open. The time of rotation (and amount of ice dispensed) is determined by the timer. May 2000 Page 5 HD150 Key Kit Installation: (KSLDK2) 1. Disconnect electrical power Electrical Shock Hazard. Disconnect electrical power before beginning procedures. Obtain typical door lock cylinder from the motel/hotel. Insert cylinder into brass fitting (most cylinders will fit). Mark place where cylinder sticks out past brass fitting. Insert cylinder into hole on plate in kit. Place switch mounting bracket behind cover plate and over fitting, with the switch below the fitting. Using the locknut provided, fasten the fitting in place with the flats vertical. Place the cylinder in the brass fitting, and secure to the fitting with the set screw. Push hotel/motel key into the cylinder and adjust lever of micro switch so the switch closes when the key is pushed all the way in. Install plate and switch assembly into dispenser. Secure with nuts removed from original plate. Remove wire #8 from normally open terminal of the dispenser switch and reconnect it to the normally open terminal of the room key microswitch. [. . . ] Disconnect electrical power before beginning procedures. Remove top front panel (in front of ice machine). Remove the front top panel (above ice chute). Reach into the opening, locate the large nut securing the wheel to the drive shaft. [. . . ]