User manual SCOTSMAN HD356

[. . . ] Scotsman reserves the right to make design changes and/or improvements at any time. Specifications and designs are subject to change without notice. Scotsman assumes no liability or responsibility of any kind for products manufactured by Scotsman that have been altered in any way, including the use of any parts and/or other components not specifically approved by Scotsman. Model HD356BE-1A HD356BS-1A HD356BE-6A HD356BS-6A HD356NE-1A HD356NS-1A HD356CE-1A HD356CS-1A Basic Electrical 115/60/1 115/60/1 220/50/1 220/50/1 115/60/1 115/60/1 115/60/1 115/60/1 Typical Amps 2. 2 2. 2 2. 2 2. 2 2. 2 2. 2 2. 2 2. 2 Vend Type Push Button Push Button Push Button Push Button Coin - 25¢ or token Coin - 25¢ or token Card Card - Finish Enamel Stainless Steel Enamel Stainless Steel Enamel Stainless Steel Enamel Stainless Steel June 1998 Page 2 HD356 Diagrams RIGHT SIDE VIEW MINIMUM CLEARNCE FOR UTILITIES CONNECTION 6. 00 in 15. 2 cm 4. 12 in 10. 5 cm 2. 38 in 6. 0 cm 24. 88 in 63. 2 cm 28. 62 in 72. 7 cm TOP VIEW 6. 34 in 16. 1 cm 27. 00 in 68. 5 cm 1. 50 in 3. 8 cm BACK VIEW FRONT VIEW CHUTE DEPRESSED POSITION ELECTRICAL CONNECTION 3/4 F. P . T. DRAIN 1. 19 in 3. 0 cm 44. 00 in 111. 8 cm 5. 25 in 13. 3 cm 7. 50 in 19. 0 cm 18. 62 in 47. 3 cm 3. 25 in 8. 2 cm 15. 00 in 38. 1 cm 30. 00 in 76. 2 cm 6. 00 in 15. 2 cm 1. 36 in 3. 4 cm 27. 28 in 69. 3 cm June 1998 Page 3 HD356 Uncrating Remove the carton from the skid. [. . . ] Note: If the chute is not all the way up, the unit cannot resupply the chute with ice. How to Use - Coin Vending The ice machine will start and run periodically to maintain the ice in the dispenser's hopper. Key 2. quarter or a special token (available from Scotsman). The unit will fill the ice chute with ice. Push down on the chute to release the ice into a waiting container. Allow the chute to return all the way up to its at-rest position. Note: If the chute is not all the way up, the unit cannot resupply the chute with ice. How to Use - Room Card The ice machine will start and run periodically to maintain the ice in the dispenser's hopper. Insert room card into slot in the front of the dispenser, and push the vend button. The unit will fill the ice chute with ice. Push down on the chute to release the ice into a waiting container. Allow the chute to return all the way up to its at-rest position. Note: If the chute is not all the way up, the unit cannot resupply the chute with ice. June 1998 Page 7 3. Locate on-off switch, move it to the ON position. The rotor should move 1/6 of a revolution on push button machines and a full revolution on coin vending machines. Record the ice machine model and serial number on the last page of this manual and on the warranty registration form. Mail the form to Scotsman ON-OFF Switch HD356 Sanitation and Maintenance Schedule: An ice system represents a sizable investment of time and money in any company's business. In order to receive the best return on that investment, periodic maintenance is required. It is the user's responsibility to see that the machine is properly maintained. Maintenance and Cleaning should be done a minimum of twice per year, and more if the ice machine is operating in a dusty area. Monthly: Unlock sink and remove it. Then pull out the removable upper drain chute. Clean out any debris that may have accumulated in it. [. . . ] Clean out any debris that might be in the chute or screens. Clean out the lower drain pan. Pour hot water into the drain to be sure that it's clean. Thoroughly spray or wash all surfaces of the drain pan, drain chute and ice chute with an approved sanitizing solution. June 1998 Page 10 HD356 Service Diagnosis Symptom Probable Cause No power to dispenser Ice chute not all the way up. No ice in hopper Dispenser On-Off switch is OFF. Push button switch does not work Coin switch (coin vending units) does not work Coin units: Cam switch #2 open Does not dispense Card switch (code card units) does not work Transformer failed Safety switch is open Relay has failed Motor of gear reducer is open or stuck Drive shaft broken Gear reducer stripped internally 50 Hz models - main transformer has failed Does not STOP dispensing Vend or cam switch stuck closed Result of ice agitation Ice fills chute by itself Rotor not timed properly with cam switch Vend switch stuck Possible Correction Check for power, reconnect if off Push ice chute up. [. . . ]