User manual SCOTSMAN ID250

[. . . ] IMPORTANT: For dispensing compressed or extruded style ice, an Ice Diverter Kit must be installed on the dispensers (see ICE DIVERTER KIT (KNUGDIV) in INSTALLATION INSTRUCTIONS section of this manual. The Ice Diverter Kit is part of the KBT46 adapter. ·ALWAYS: disconnect power to the dispenser before servicing or cleaning. ·NEVER: place hands inside of hopper or gate area without disconnecting power to the dispenser. dispenser is energized! ·Agitator rotation occurs automatically when ·ALWAYS: be sure the removable lid is properly installed to prevent unauthorized access to the hopper interior and possible contamination of the ice. clean of ice cubes. ·ALWAYS: be sure the upper and lower front ·ALWAYS: keep area around the dispenser ·CAUTION: Dispenser cannot be used with crushed or flaked ice. Use of bagged ice, which has frozen into large chunks, can void warranty. [. . . ] If from below, only remove the bottom access panel. A hole is not needed at the intersection of C and D, unless the back access panel is retained. May 2002 Page 6 ID150, ID200, ID250 ICE DIVERTER KIT NOTE: For dispensing Scotsman Nugget Ice: 1. Remove ice chute and discard gate restrictor. Install ice diverter on gate mounting plate as shown below. Apply RTV to back surface of ice diverter, to seal to gate mounting plate. Reinstall merchandiser and energize unit. Note: The agitation timer must be adjusted to the MINIMUM position when dispensing nugget ice. The timer is located in the electrical box. Set that to the minimum of one half second. Check the label in the electrical box to confirm these procedures: ·Rotate the Motor On Time adjustment fully CCW to get the half second setting. get the 3 hour setting. ·Rotate the Off Time adjustment fully CW to May 2002 Page 7 ID150, ID200, ID250 INITIAL START UP 1. Sanitize the ice storage system as instructed on page 11. Plug the unit's power cord into an electrical outlet and the lighted sign should come on. In normal operation, pushing the ice dispenser mechanism will cause ice to flow from the ice chute. Ice flow will continue until the dispenser mechanism is released. CAUTION: Use caution to avoid spilling ice when filling dispenser. Clean up immediately any spilled ice from filling or operating the unit. To prevent contamination of ice, the lid must be installed on the unit at all times. If the dispenser fails to dispense ice or beverage see troubleshooting guide. May 2002 Page 8 ID150, ID200, ID250 GATE RESTRICTOR PLATE CAUTION: Disconnect power to dispenser before installing, removing or adjusting restrictor. ADJUSTMENT This plate may be adjusted as shown to reduce or increase the dispensing rate of ice, especially desirable when using glasses or other containers with small openings. Adjustment can be made by sliding up or down with nuts loosened, to obtain the desired amount of restriction. May 2002 Page 9 ID150, ID200, ID250 CLEANING AND SANITIZING The sink, grill and splash panel area should be cleaned daily. [. . . ] Re-assemble ice chute assembly. May 2002 Page 11 11. Using a mechanical spray bottle filled with sanitizing solution, spray the inside of the ice chute. Wipe the top edge of the ice hopper with the sanitizing solution, allow to air dry. Pour in fresh, sanitary ice and replace the cover. [. . . ]