User manual SCOTSMAN RFE33

[. . . ] RFE33 Introduction The Scotsman RFE33 Compact Refrigerator is a unique product, capable of being built into a cabinet because of its front vented, forced-air cooling system. It's also designed to be a companion to Scotsman's DCE33 Automatic Ice Machine. To prevent door interference when installed to the left of a DCE33, the RFE33 comes from the factory with the door hinged on the left. The door swing may be reversed to suit the installation. [. . . ] With the door open enough to see both screws at the top door hinge, remove the two screws. Remove the single screw and the hinge filler plate from the top of the door. Install the other filler plate (shipped inside refrigerator compartment) onto the top corner of the door where the hinge was. Remove the three plastic plugs from the top front corner where the hinge will mount. Remove the three plastic plugs from the lower front corner where that hinge will mount. Remove the three screws holding the top hinge to the cabinet. Remove that hinge from the top and, flipping it upside down, install it onto the bottom of the door, on the opposite side using the original screws. Remove the hinge assembly from the bottom of the door, and flip it upside down; secure it to the cabinet at the opposite side top position with the original screws. Secure the door to the top hinge with the original screws. Secure the bottom hinge to the cabinet with the original screws. Place the plastic plugs removed earlier into the empty holes. Check operation of the door by opening and closing it. Hinge Door Handle Filler Plate Hinge Magnetic Gasket Door Reverse Hinges From Top to Bottom and Left to Right To Reverse Door Swing November 1995 Page 5 RFE33 Installation The machine should not be installed in a room that falls below 50oF. Level the cabinet by turning the leveling legs at the base of the refrigerator. Plug the refrigerator into the electrical power supply. Do not slide into place until the unit has been started. Operation: To begin operation: Open the door, locate the temperature control knob in the upper right portion of the interior and rotate that knob clockwise until it is about at the mid position. The compressor and fan motor should both be operating, unless the refrigerator is below 35oF. Check that air is flowing out the right side of the grill. The metal portion of the freezing compartment will soon feel cold. That is the signal that the refrigerator is functioning and the cabinet may now be placed in its installed position. The refrigerator will require some time to cool the air and cabinet interior. If desired, a thermometer may be placed in the interior and the temperature checked. The RFE33 should maintain approximately 40oF. [. . . ] Lift the freezing compartment door and locate the hinge wire behind the right side of that door. Carefully push the hinge wire toward the center of the door until the end of the wire has been pulled out of the hole in the upper left wall of the thermostat housing. Remove the left hinge wire and spacer from the left wall of the refrigerator liner. Remove any ice trays that may be in the freezing compartment. [. . . ]