User manual SDMO ALIZE 3000 2800W

[. . . ] Safety features (if fitted, see specifications table) 6. Recommendations Thank you for buying one of our generating sets. We recommend that you read this manual carefully and follow the safety and maintenance advice and user instructions for your generating set very closely. The information contained in this manual is taken from technical data available at the time of print. [. . . ] Fill the oil sump to the top using a funnel. Screw the cap tightly back onto the filler tube. Checking the fuel level Stop the motor before filling up with fuel and fill up in a well-ventilated area. Do not smoke, or bring naked flames or sparks near to the area where you are filling up with fuel or where the fuel is stored. Danger Only use clean fuel without any water. Do not overfill the tank (there should not be any fuel in the filler neck). When you have filled up, ensure that the tank cap is closed correctly. Take care not to spill any fuel when filling the tank. Before starting up the generating set, and if any fuel has been spilt, make sure that it has dried and that the vapours have cleared away. Check the level of fuel on the fuel indicator (no. A) and fill with fuel until "F" is displayed: Unscrew fuel tank (no. A) using a funnel, taking care not to spill any fuel. Screw the fuel filler cap back onto the fuel tank. Earthing the generating set To earth the generating set, use a 10 mm2 copper wire attached to the generating set earth connection and to an earthing rod of galvanised steel set in the ground to a depth of 1 metre. This also dissipates the static electricity that builds up in the electrical machines. Positioning the generating set for operation Place the generating set on a flat, horizontal surface which is firm enough to prevent the set sinking down (under no circumstances should the set tilt any direction by more than 10°). Choose a site that is clean, well-ventilated and sheltered from bad weather, and store the additional supplies of oil and fuel within close proximity, although respecting a certain distance for safety. Starting procedure Open the petrol tap (no. Note: Do not use the choke when the engine is warm or when the atmospheric temperature is high. A) correctly and pull it slowly until some resistance is felt, then let it return gradually. Take the starting handle again correctly, then pull the cord sharply and rapidly (pull it right out, using both hands if necessary). Allow the handle to return slowly by hand. [. . . ] Open the fuel tap and drain the fuel from the tank into a suitable container. Drain the carburettor by loosening the drain screw. Remove the spark plug and pour approximately 15 ml of oil into the cylinder, then refit the spark plug. refit the closure panels exhaust end and starter end. [. . . ]