User manual SDMO NEO 3000 2600W

[. . . ] Recommendations Read this manual carefully before use. The safety advice and the usage and maintenance instructions for the generating set must always be strictly adhered to. Warning The information contained in this manual is taken from technical data available at the time of print. In line with our policy of continually improving the quality of our products, this information may be amended without warning. [. . . ] Important Open the inspection cover (fig. Checking the fuel level The fuel must be refilled when the engine is off and according to safety guidelines (see § Filling with fuel). Before opening the fuel tank cap, always set the fuel tank aeration pointer to the RUN position. Taking care not to spill the fuel, use a funnel to fill the tank up to its filling limit. Do not overfill the tank (there should not be any fuel in the filler neck). After the tank has been filled, always ensure that the filler plug is properly tightened. If any fuel has been spilt, make sure that it has dried and that any vapours have cleared before starting up the Important generating set. Screw the fuel tank cap back onto the fuel tank. Checking the air filter Before starting the generating set, check the air filter. Important Open the inspection cover (fig. 9) is set to "MAX", the generating set can quickly respond to a high inrush current (when running under no load, it runs at 3800 rpm). eCO The "ECO" position is useful for small loads. To reduce noise emissions, the generating set runs at its min. When a power above 200 W is required, the speed of rotation gradually increases. Switching off Shut down and disconnect the devices. Allow the engine to run idle for 1 or 2 min. Always ensure suitable ventilation for the generating set. Even after shut down, the engine continues to dissipate heat. Oil cut-out If there is no oil in the engine sump or if the oil pressure is low, the oil safety mechanism automatically stops the engine to prevent any damage. If this occurs, check the engine oil level and top it up if necessary before looking for any other cause of the problem. In the event of an overload and/or short circuit, the supply of electrical energy may be cut. If necessary, replace the circuit breakers in the generating set with circuit breakers with identical nominal ratings and specifications. [. . . ] 7 Precauções contra os gases de escape O óxido de carbono presente nos gases de escape pode provocar a morte, se a taxa de concentração for excessiva no ar que se respira. Se for necessário efectuar uma operação no interior de um edifício, é imperativo que proceda à evacuação dos gases de escape para o exterior e preveja uma ventilação adequada, para que as pessoas ou os animais presentes não sejam afectados. Se o grupo electrogéneo for utilizado em superfícies de madeiras ou em terrenos ervosos e a panela de escape não estiver equipada com um pára-faíscas, limpe o terreno numa área suficientemente ampla e vigie se as faíscas não provoquem nenhum incêndio. I de fall en eller flera flytt- eller bärbara apparater bara används tillfälligtvis, är det inte nödvändigt att jorda generatoraggregatet, men det är nödvändigt att följa följande regler: a) All utrustning som är ansluten till generatoraggregatets strömuttag skall vara sammankopplade med en skyddsbrytare; utjämning av potentialen får man om alla skarvkablar till utrustning med skyddsklass I har en skyddsledning med PE-anslutning (GRÖN-GUL) rätt kopplad till kopplingsplinten på generatoraggregatet (denna skyddsledning behövs inte för utrustning av skyddsklass II). [. . . ]