User manual SEAGATE DIAMONDMAX 17

[. . . ] DiamondMax 17 80-160GB Serial ATA May 11, 2006 PN: 1937 Revisions REV A EC NO. 2114982 CHAPTER All DESCRIPTION Initial release. PN: 1937 DATE 05/11/06 © May 11, 2006 Maxtor Corporation. This publication could include technical inaccuracies or typographical errors. Changes are periodically made to the information herein ­ which will be incorporated in revised editions of the publication. [. . . ] 15: 14: 13: 12: 11: 10: 9: 8: Obsolete 1 = NOP command enabled 1 = READ BUFFER command enabled 1 = WRITE BUFFER command enabled Obsolete 1 = Host Protected Area feature set enabled 1 = DEVICE RESET command enabled 1 = SERVICE interrupt enabled 5-10 Maxtor DiamondMax 17 80-160GB Serial ATA Hard Disk Drive SATA Bus Interface and ATA Commands Word 85 7: 6: 5: 4: 3: 2: 1: 0: 86 Content Description 1 = release interrupt enabled 1 = look-ahead enabled 1 = write cache enabled Shall be cleared to zero to indicate that the PACKET Command feature set is not supported. 1 = Power Management feature set enabled 1 = Removable Media feature set enabled 1 = Security Mode feature set enabled 1 = SMART feature set enabled Command set/feature enabled. 15-14: 13: 12: 11: 10: 9: 8: 7: 6: 5: 4: 3: 2: 1: 0: Reserved 1 = FLUSH CACHE EXT command supported 1 = FLUSH CACHE command supported 1 = Device Configuration Overlay supported 1 = 48-bit Address features set supported 1 = Automatic Acoustic Management feature set enabled 1 = SET MAX security extension enabled by SET MAX SET PASSWORD See Address Offset Reserved Area Boot, INCITS TR27:2001 1 = SET FEATURES subcommand required to spin-up after power-up 1 = Power-Up In Standby feature set enabled 1 = Removable Media Status Notification feature set enabled 1 = Advanced Power Management feature set enabled 1 = CFA feature set enabled 1 = READ/WRITE DMA QUEUED command supported 1 = DOWNLOAD MICROCODE command supported 87 Command set/feature default. 15: 14: 13-8: 7: Shall be cleared to zero Shall be set to one Reserved 1 = WRITE DMA QUEUED FUA EXT command supported Maxtor DiamondMax 17 80-160GB Serial ATA Hard Disk Drive 5-11 SATA Bus Interface and ATA Commands Word 87 6: 5: 4: 3: 2: 1: 0: 88 15: 14: 13: 12: 11: 10: 9: 8: 7: 6: 5: 4: 3: 2: 1: 0: 89 90 91 92 Content Description 1 = WRITE DMA FUA EXT and WRITE MULTIPLE FUA EXT commands supported General Purpose Logging feature set supported 1 = Valid CONFIGURE STREAM command has been executed 1 = Media Card Pass Through Command feature set enabled 1 = Media serial number is valid 1 = SMART self-test supported 1 = SMART error logging supported Reserved 1 = Ultra DMA mode 6 is selected. 0 = Ultra DMA mode 6 is not selected 1 = Ultra DMA mode 5 is selected. 0 = Ultra DMA mode 5 is not selected 1 = Ultra DMA mode 4 is selected. 0 = Ultra DMA mode 4 is not selected 1 = Ultra DMA mode 3 is selected. 0 = Ultra DMA mode 3 is not selected 1 = Ultra DMA mode 2 is selected. 0 = Ultra DMA mode 2 is not selected 1 = Ultra DMA mode 1 is selected. 0 = Ultra DMA mode 1 is not selected 1 = Ultra DMA mode 0 is selected. 0 = Ultra DMA mode 0 is not selected Reserved 1 = Ultra DMA mode 6 and below are supported 1 = Ultra DMA mode 5 and below are supported 1 = Ultra DMA mode 4 and below are supported 1 = Ultra DMA mode 3 and below are supported 1 = Ultra DMA mode 2 and below are supported 1 = Ultra DMA mode 1 and below are supported 1 = Ultra DMA mode 0 is supported Time required for security erase unit completion Time required for Enhanced security erase completion Current advanced power management value Master Password Revision Code 5-12 Maxtor DiamondMax 17 80-160GB Serial ATA Hard Disk Drive SATA Bus Interface and ATA Commands Word 93 Content Description Hardware reset result. The contents of bits (12:0) of this word shall change only during the execution of a hardware reset 15: 14: 13: 12-8: Shall be cleared to zero. 0 = device detected CBLID- below ViL Device 1 hardware reset result. Device 0 shall clear these bits to zero. Device shall set these bits as follows: 12: Reserved. 10-9: These bits indicate how Device 1 determined the device number: 00 = Reserved. 11 = some other method was used or the method is unknown. Device 1 shall clear these bits to zero. Device shall set these bits as follows: 7: Reserved. 6: 0 = Device 0 does not respond when Device 1 is selected. 1 = Device 0 responds when Device 1 is selected. 5: 0 = Device 0 did not detect the assertion of DASP-. [. . . ] SUBSTRATE ­ The material the disk platter is made of beneath the magnetic coating. Hard disks are generally made of aluminum or magnesium alloy (or glass, for optical disks) while the substrate of floppies is usually mylar. SURFACE ­ The top or bottom side of the platter which is coated with the magnetic material for recording data. On some drives one surface may be reserved for positioning information. U UNFORMATTED CAPACITY ­ The total number of bytes of data that could be fit onto a disk. [. . . ]