User manual SEAGATE FIREBALL PLUS KA JUMPER SETTINGS

[. . . ] Fireball Plus KA Jumper Settings Jumper Settings DS Stand Alone (Default) Master with Slave Present Slave to Master Cable Select * ON ON OFF OFF CS OFF OFF OFF ON PK X X X X Rsvd OFF OFF OFF OFF X= PK is a Parking position. [. . . ] For Ultra ATA/66 compliant cables, the master drive is placed on the outside (end) cable connector and the slave drive is placed on the intermediate cable connector. 1 of 1 Fireball Plus KA fireball_plus_ka_jumper. pdf Jumper Locations The Maxtor® FireballTM Plus KA disk drive has only one location where user configurable jumpers are found. The jumper block is incorporated into the ATA / IDE cable connector. Using the jumper pins you can establish the drive Master/Slave configuration. The Maxtor Fireball Plus KA was developed by Quantum Corporation prior to its merger with Maxtor. BIOS Settings The following BIOS parameters are provided for customers needing to manually configure the Fireball Plus KA disk drive. Both base 2 and base 10 capacity values are displayed. 6. 4 GB Logical Cylinders Logical Heads Logical Sectors/Track Total Logical Sectors Base 10 Capacity Base 2 Capacity 13, 328 15 63 12, 594, 960 6, 449 MB 6, 150 MB 9. 1 GB 16, 383 * 16 63 18, 041, 184 9, 237 MB 8, 809 MB 13. 6 GB 16, 383 * 16 63 27, 067, 824 13, 858 MB 13, 217 MB 18. 2 GB 16, 383 * 16 63 36, 094, 464 18, 480 MB 17, 624 MB *Note: Default Logical Cylinder value is limited to 16, 383 as per the ATA-4 specification. Capacity may be restricted to 8. 4GB (or less) due to system BIOS limitations. Check with your system manufacturer to determine if your BIOS supports LBA mode for ATA hard drives greater than 8. 4GB. 2 of 2 Fireball Plus KA fireball_plus_ka_jumper. pdf Special Considerations Hard drives greater than 2. 1GB may need to be divided into multiple partitions / logical drives. MS-DOS versions 4. 0 through 6. 22 allow a maximum primary partition / logical drive size of 2. 1GB and are limited to 8. 4GB in physical drive capacity. [. . . ] The Ultra ATA cables use the Cable Select method rather than a master / slave scheme, so the drive must be jumpered to enable Cable Select. For further review: · · · · · · · · · · ATA Configuration Card (Includes Drive Mounting) ATA Installation Flowchart ATA Installation Guide for Windows NT ATA Installation Guide for Windows95/98 BIOS Support for logical cylinder values > 4095 DOS/Windows 95 logical drive limitations Knowledge Base Ultra ATA/66 Bus Interface Ultra ATA/66 Compatibility with Award BIOS Windows NT 4. 0 Capacity Issue 3 of 3 [. . . ]