User manual SEGA CLUB KART SWP

[. . . ] RND-0043 REV 0 SERVICE MANUAL UPRIGHT TYPE Before using this product, read this SERVICE MANUAL carefully to understand the contents stated herein. After reading this manual, be sure to keep it available nearby the product or somewhere convenient in order to be able to refer to it whenever necessary. Manufactured in the UK by CONTENTS 1. BEFORE USING THIS PRODUCT. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1. 1. [. . . ] Touching places other than those specified can cause electric shock and short circuit. Disconnect the machine from the supply before attempting the replacement of any lamp. · When performing work, be sure to turn power off. Working with power on can cause an electric shock or short circuit. · Hot fluorescent lamps can cause burns. · Use a secure step to improve access to the upper parts of the cabinet. · Only QUALIFIED SERVICE PERSONNEL should replace lamps. 3. 9. 1. Turn power OFF at the Main Switch and remove the IEC lead. Open the Control Panel (see Section 3. 7). Remove the two truss screws and open the entry panel. 4. By using a flat bladed screwdriver, remove the four screw caps from the front panel. Take out the four tamperproof screws and the two lower screws, and carefully take off the Front Panel. Remove the Billboard assembly as detailed in Section 3. 10. 2. Remove the four screws and the Earth Link to allow the Billboard Holder to be removed. The Fluorescent lamp can be removed by disconnecting the two end caps and withdrawing the Lamp upwards through the two mounting clips. After replacing the lamp, reassemble in reverse order, being sure to replace the Earth Link between the Billboard Holder and frame. 33 34 3. 10. GAME BOARD · When performing work, be sure to turn power off. Working with power on can cause an electric shock or short circuit. · Be careful not to damage wiring. Damaged wiring can cause an electric shock or short circuit. · The voltage/amperage ratings for the Game Board are 3. 3V 12A, 5. 0V 10A and 12V 2A. To avoid risk of fire, never use any board with supply requirements exceeding the above. · When replacing the Game Board with one not of JAMMA standard, be sure to use only the harness supplied by the manufacturer of the Game Board. [. . . ] SERVICE CREDITS Total amount of service credits given by service switch. When pressing TEST BUTTON, following screen will appear. 70 6. 3. 8. 4. BOOKKEEPING 4/4 Screen SETTINGS: PAYOUT: Payout ratio percentage TOTAL: BET: Number of total bet WIN: Number of total win P/O: Total payout ratio percentage D D RACE: BET: Number of DOSH DASH RACE bets WIN: Number of DOSH DASH RACE wins P/O: Payout ratio percentage of DOSH DASH RACE DOUBLE UP: BET: Number of DOUBLE UP CHALLENGE bets WIN: Number of DOUBLE UP CHALLENGE wins P/O: Payout ratio percentage of DOUBLE UP CHALLENGE CONTINUE BET: Number of CONTINUE bets WIN: Number of CONTINUE wins P/O: Payout ratio percentage of CONTINUE. DOSH DASH RACE: WINS / GAMES (WIN%) BEGINNER: 0 / 0 (0. 0%) INTERMEDIATE: 0 / 0 (0. 0%) EXPERT: 0 / 0 (0. 0%) 71 Number of winning game, total game played, and winning ratio percentage between each course will be displayed. WINMAX WINAVG TTLAVG BEGINNER: 0 0. 0 0. 0 INTERMEDIATE: 0 0. 0 0. 0 EXPERT: 0 0. 0 Max winning, average winning, and average winning (regardless of actual winning) on DOSH DASH RACE will be shown. [. . . ]